FuzzDog Vintage POW! Manual
Read Online
Read the FuzzDog Vintage POW! Manual online using the built-in PDF viewer.
Key Pages of Document
Overdriver runs at 9v, Power Boost at 18v (though it works ok at 9v). OVERDRIVER POWER BOOST ...
BOM OD PB R1 120K 120K R2 6K8 4K7 R3 150K 150K R4 Jumper 470R R5A Empty 12K R5B 12K Empty R6 1K8 1K8 R7 4K7 4K7 R8 39K 39K R9 5K6 5K6 R10 4K7 4K7 R11 33K 33K R12 150K 180K R13 1K8 3K9 R14 470R 1K R15 470R 1K2 RLED 2K2 4K7 OD PB C1 220n 220n C2 22u 22u C3 22u 22u C4 220p 220p C5 10u 10u C6 10n 10n C7 10n 10n C8 100n 100n C9 100n 100n C10 10u 22u C11 220n 220n C12 22u 10u C13 47u 47u Q1-3 BC109 or BC169C D1 1N4001 DRIVE 5KC* TREB 100KB BASS 100KB VOL 100KA * ...
when you remove the jack plug from the input, and also when a DC plug is inserted. Snap the little metal tag off the pots to mount them flush in the box. You MUST use some kind of heat sink on the legs of the transistors when soldering. They aren’t keen on heat. Any more than 3-4 seconds of iron and they’re toast. Recommended assembly order: Resistors, Caps, Transistors, Wires, Pots I’ve incorporated ...
Once you’ve finished the circuit it makes sense to test is before starting on the switch and LED wiring. It’ll cut down troubleshooting time in the long run. If the circuit works at this stage, but it doesn’t once you wire up the switch - guess what? You’ve probably made a mistake with the switch. Solder some nice, long lengths of wire to the board connections for 9V, GND, IN and OUT. Connect IN and OUT to the jacks as shown. Connec ...
The Board GND connections don’t all have to directly attach to the board. You can run a couple of wires from the DC connector, one to the board, another to the IN jack, then daisy chain that over to the OUT jack. It doesn’t matter how they all connect, as long as they do. This circuit is standard, Negative GND. Your power supply should be Tip Negative / Sleeve Positive. That’s the same as your standard pedals (Boss etc), an ...
The Board GND connections don’t all have to directly attach to the board. You can run a couple of wires from the DC connector, one to the board, another to the IN jack, then daisy chain that over to the OUT jack. It doesn’t matter how they all connect, as long as they do. This circuit is standard, Negative GND. Your power supply should be Tip Negative / Sleeve Positive. That’s the same as your standard pedals (Boss etc), ...
