Graco E-Flo Installation Manual

E-Flo® iQ Dispense System For dispensing and metering sealants, adhesives, and other medium to high viscosity fluids. For professional use only. Not approved for use in explosive atmospheres or hazardous (classified) locations. See page 4 for system component information. Important Safety Instructions Read all warnings and in ...

Dispense System Configurator. . . . . . . . . . . . . . . . 4 Dispense System Components. . . . . . . . . . . . . . . . 5 iQ Ram Supply Units . . . . . . . . . . . . . . . . . . . . . . 5 iQ Dispense Valves . . . . . . . . . . . . . . . . . . . . . . . 6 Hose Options ...

System Kits and Accessories. . . . . . . . . . . . . . . 79 Drum Kits and Accessories . . . . . . . . . . . . . . . . 80 CAN Cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 I/O Cable, 122029 . . . . . . . . . . . . . . . . . . . . . . . 81 Plat ...

4 333586E Dispense System Configurator The E-Flo iQ dispense system provides the flexibility to configure a complete system to meet your specific needs. This includes offering multiple combinations of the following components: • iQ Ram Supply Units • iQ Dispense Valves • Hoses and connectors For dispense system component in ...

333586E 5 Dispense System Components NOTE: The Heated option for the E-Flo iQ system is for warm melt applications with a maximum temperature of 70° C (158° F). iQ Ram Supply Units Check the identification plate (ID) on the back of the ram post near the Power Junction Box (AJ) for the seven-digit part number of the iQ ram supply ...

6 333586E iQ Dispense Valves Check the identification plate on the valve for the ten-digit part number of the iQ dispense valve. Use the following matrix to define the construction of the valve, based on the ten digits. For example, Part No. V25AB060BA represents a valve (V) with 1/4” NPT inlet ports (25), NPT tip size (A), ball/ ...

333586E 7 Dispense System Pressure Due to factors such as the dispensing system design, the material being pumped, and the flow rate, the dynamic pressure will not reach the rated working (stall) pressure of the system. Pump Working (Stall) Pressure Max Dynamic (Run) Pressure Lower Size psi bar MPa psi bar MPa Check-Mate 200CS/CM 4,0 ...

exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product ...

Moving parts can pinch, cut or amputate fingers and other body parts. • Keep clear of moving parts. • Do not operate equipment with protective guards or covers removed. • Equipment can start without warning. Before checking, moving, or servicing equipment, follow the Pressure Relief Procedure and disconnect all po ...

Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Specifications in all equipment manuals. • Use fluids and solvent ...