Fitnex T70 Quick Start Manual

Qty. A1. M10X15 Round Socket Head Screw---------[12pcs] C1. M10 Radian Washer----------------------------[12pcs] D1. M6 Allen Wrench-------------------------------[1pcs ] 40 20 60 80 100 140 160 120 PAGE 1 A1 C1 D1 ...

with screw(A1) and radian washer(C1). STEP 2. Pulling out the cable from main frame through upright tube(B). T70 cable B B A1 C1 C1 A1 A1 C1 C1 A1 PAGE 3 STEP 3. Using tool(D1) to tighten console set(D) with screw(A1) and washer(C1). Connecting cables. NOTICE:CABLES CAN NOT BE CRUSHED. D A1 C1 A1 C1 ...

power on, position the rear roller using the ' T ' wrench ( refer to the drawing if needed ) and make 3 turns clockwise to avoid the belt from slipping If belt is too far to the left side 1) turn the left roller bolt 1/4 turn clockwise(tighten) 2) turn the right roller bolt 1/4 turn counterclockwise(loosen) If belt is too far to the right side 1) turn the right roller bolt 1/4 turn clockwise(tighten) 2) turn the left roller bolt 1/4 turn counterclockwise(loosen) PAGE 4 T70 ...

If when you plant your foot on the belt, you can feel a sliping sensation then the belt has been stretched and is slipping over the roller. This is normal and common adjustment on a new treadmill. To eliminate this slipping, tighten both sides of the rear roller by turning a allen wrench 1/4 as shown above. Try the treadmill again to check for slipping. Repeat if necessary, but NEVER TURN the roller bolt more than 1/4 turn at a time. CAUTION:OVER TIGHTENING OF THE ROLLER WILL SEVERELY SHORTEN THE LIFE OF THE BELT AND MAY CAUSE FURTHER DAMAGE TO OTHER COMPONENTS. Drive Belt If you have tightened the running belt and are still experi ...