Fantech RIL-100 Installation & Maintenance Instructions

are fully adhered to. 1.2. All electrical installations must be carried out by a suitably qualified and competent personnel in accordance with all statutory requirements. 1.3. The fan is designed for use in an ambient temperature of up to 40°C. It is not suitable for corrosive or explosive atmospheres. 1.4. The installer should provide easy access to the fan to facilitate future maintenance, and ensure that the fan is adequately supported. Page 2 of 4 RIL-100 100 60 88 80 303 97 176 2 RIL-125 100 60 88 80 258 123 176 2

with reduced physical sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for their safety. Children should be supervised to ensure that they do not play with the product. 1.6 Precautions must be taken to avoid back-flow of gases into the room from the open flue of gas or other fuel burning appliances. 1.7 A minimum of one (1) metre of duct is to be fitted to the fan inlet and discharge spigots. 1.8 To avoid a hazard, a damaged supply cord must be replaced by the manufacturer. Installation Warning: The fan must be isolated from the power supply during installation and maintenance. 2.1. Upon receipt, the fan should be inspected for any damage. 2.2. Check the details on the rating plate to ensure that the correct power supply is available 2.3. Means for electrical disconnection must be incorporated in the wiring installation in accordance with the relevant wiring regulations. 2.4. Remove the fan body from the spigots that are attached to the base, by releasing the two retaining clamps RIL-100 / RIL-125. Page 3 of 4