Yamaha AS1000 - Amplifier Owner's Manual

Text of the manual

HiFi Began with Yamaha

Yamaha’s involvement with and passion for music goes back more than a century, to when we built our first reed organ in 1887. Now we are the world’s leading producer of pianos and other musical instruments, and are involved with music in many other ways as well. We manufacture professional recording equipment, we design concert hal

Excellence in Audio Achievement

1922: We introduced a high-quality hand- wound phonograph. Since 1955, we have released many HiFi components, including turntables, tuners, integrated amplifiers, control amplifiers, power amplifiers and speakers. NS-20 Monitor Speaker

◆Floating balanced circuit design

The perfectly symmetrical, fully new floating balanced power amplifier maximizes the performance of the analog amplifier. ◆Parallel volume and tone control ◆Four independent high capacity power supplies ◆Horizontally symmetrical structure ◆Phono amplifier with fully discrete structure ◆Newly developed heavyw

Controls and functions

■ Front panel (left side) 1 POWER Press upward or downward to turn on or off this unit. y The POWER indicator above lights up when this unit is turned on. • If the POWER indicator flashes when you turn on this unit, disconnect the power cable and refer to the troubleshooting section (page 24). • When you turn on this unit, t

3 PHONES jack

Outputs audio for private listening with headphones. When headphones are plugged in: – Both speaker sets connected to the SPEAKERS L/R CH A and B terminals are turned off. – No signals are output at the PRE OUT jacks, while signals are output at the REC jacks. – You cannot select MAIN DIRECT as the input source. – If headphones are

Controls and functions

■ Front panel (right side) 5 BASS Increases or decreases the low frequency response. The center position produces a flat response. Control range: –9 dB to +9 dB 6 TREBLE Increases or decreases the high frequency response. The center position produces a flat response. Control range: –9 dB to +9 dB y When both the BASS and TRE

8 INPUT selector

Selects the input source you want to listen to. The audio signals of the selected input source are also output at the REC jacks. y • The input source names correspond to the names of the connection jacks on the rear panel. • Switch to the MAIN DIRECT position to select the component connected to the MAIN IN jacks. When MAIN DIRECT i

Other Amplifier Manuals