Directed DS4+ Installation Manual
Text of the manual
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle’s
electrical system and components.
2017-11-21
© 2017 Directed, Vista CA
DS4+
Designed by Installers for Installers
Warning! Safety first........................................................................................................................ 3
Introduction..................................................................................................................................... 4
Pre-installation and application warnings..................
Warning! Safety first
The following safety warnings must be observed at all times:
•
Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer.
•
When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never
operate the system in
The SUBARU2 firmware for DS4+ is compatible with specific Subaru vehicles. It is a complete solution for
remote start, security (when security features are enabled), bypass, and features built in Bluetooth 4.0 allowing
you to configure and control your system. This guide provides information on the installation of the module using
SUBARU2. Pleas
Vehicle application guide
The following table lists the vehicles and features which are compatible with this product. The number assigned to each year
allows you to determine which installation type should be used for your vehicle.
Vehicles
2018
2017
2016
2015
2014
2013
2012
2011
2010
PK-Immobilizer Bypass-Data No Key Req'd
CC-Heated Mirrors
CC-Rear Window D
