Delta MultiChoice 14 Series Installation Instructions Manual

Table of Contents: Warranties...................................................................................Page 2 Installation Instructions................................................................Pages 3 - 12 Clean and care............................................................... ...

2 Parts and Finish. All parts (other than electronic parts and batteries) and finishes of this Delta® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed. For commercial purchasers, the ...

1 MultiChoice ® Rough-In Installation (When your product requires) 3 SHUT OFF WATER SUPPLIES. Consider the type and thickness of your finished wall before placing your stringer back plate. • Install the body (1) so the surface of the finished wall is flush with the front of the plasterguard (2) ± 3/8". Note: For models with stops (3), p ...

4 • Connect valve body to water supplies using the proper fittings for your valve body type (copper tubing, iron pipe or Pex). Note: (1) is the cold inlet port and (2) is the hot inlet port. • If either of the two outlet ports is to be unused, seal the port with a pipe plug. • Remove bonnet (1). NOTICE: Avoid soldering at high temp ...

5 • Connect top outlet (1) to shower pipe with proper fittings. • Connect bottom outlet (2) to tub spout pipe with proper fittings. • Pipe (3) between valve body and tub spout must be a minimum of 1/2" (13 mm) copper pipe or 1/2" (13 mm) iron pipe in a straight drop no less than 8" (203 mm) but no more than 18" (457 mm) long with on ...

2 Cartridge Installation Installation A. B. Turn off water supplies. Remove bonnet nut (1) and test cap (2) from the body. If this is not a thin wall mounting, the entire plasterguard (3) may be removed. If screen (4) is in place, remove before installing cartridge. Rotate the cartridge (1) so the words “hot side” (2) appear on the left. ...

58045 3 Shower Head and Tub Spout Installation A. FOR SHOWER HEAD INSTALLATION: Connect top outlet (1) to shower arm (2) with proper fittings. To prevent damage to finish on shower arm, insert wall end of shower arm into shower flange (3) before screwing arm into riser connection. Thread shower head (4) onto shower arm. Apply plumber tape to ...

8 FOR TUB SPOUT INSTALLATION: Refer to the installation instructions supplied with your spout. Do not connect deck mount spouts to in-wall valves. Do not use hand showers connected in lieu of a tub spout to a tub/shower valve. Do not use PEX tubing for tub spout drop. ...

4 IMPORTANT: The Rotational Limit Stop is used to limit the amount of hot water available such that, if set properly, the user will not be scalded if the handle accidentally is rotated all the way to “hot” when a person is showering or filling a tub. The first position allows the LEAST amount of hot water to mix with the cold water in th ...

IMPORTANT: The Rotational Limit Stop is used to limit the amount of hot water available such that, if set properly, a scald injury is less likely to occur if the handle accidentally is rotated all the way to “hot” when a person is showering or filling a tub. The first position allows the LEAST amount of hot water to mix with the cold wa ...