Checkline TI-25LTX Operating Manual

Text of the manual

TABLE OF CONTENTS

1.0 Introduction........................................................................................................................... 1 1.1 Disclaimer 2.0 Keypad, Menu, Display & Connectors................................................................................ 3 2.1 ON/OFF/ENTER Key0 2.2 PRB 0 Key 2.3 LIGHT

– 2 –

1.0 INTRODUCTION The Checkline model TI-25LTX Ultrasonic Thickness Gauge accurately measures the thickness of steel. This gauge uses the “pulse-echo” principle of ultrasonic testing where a short ultrasonic signal is transmitted from the probe. The signal travels through the measurement sample until it is reflected back towards the probe from

– 3 –

2.0 KEYPAD, MENU, DISPLAY & CONNECTORS The Keypad 2.1 ON/OFF/ENTER Key The ON/OFF/ENTER key powers the unit ON or OFF. Since the same key is also used as an ENTER key, the gauge is powered off by pressing and holding down the key until the unit powers off. Once the gauge is initially powered on, this key will function as the ENTER key, similar t

– 4 –

2.3 LIGHT Key The LIGHT key accesses the backlight setting of the LCD display. The backlight has three setting options; ON, OFF, AUTO. The auto option will only illuminate the display when the TI-25LTX is measuring, or receiving an echo. If either ON or AUTO are selected, there are three brightness options, LO, MED, HI, to select a preferred ove

– 5 –

D. Stability/Repeatability Indicator: This is used in conjunction with the thickness measurement as a reference for the validity of the measurement. The TI-25LTX takes multiple measurements per second, and when all the vertical bars are illuminated, it’s a reference that the same thickness value is reliably being measured multiple times per seco

– 6 –

The transducer must be used correctly in order for the TI-25LTX to produce accurate, reliable measurements. Below is a short description of the transducer, followed by instructions for its use. This is a bottom view of a typical transducer. The two semicircles of the wear face are visible, as is the barrier separating them. One of the semicircles i

– 7 –

beneath the transducer, and that the transducer is seated flat against the material. If the condition persists, it may be necessary to select a different transducer (size or frequency) for the material being measured. See section 4.1 for information on transducer selection. While the transducer is in contact with the material that is being measured

Other Measuring Instruments Manuals