Component Playgrounds MT32-10 Manual
Text of Component Playgrounds MT32-10 Manual
Thank you for purchasing your equipment from Component Playgrounds!!! We are proud of our
commercial grade products made for kids of all ages & sizes, and we are confident that you will enjoy
your equipment for many years.
Because you have purchased a top of the line commercial grade product, you will need to be
aware of some specific shipping requirements that may be different from shipments you have received in
the past through other deliv
MT32-10 Swing Set
Quantity
Description
1
Box Containing Swing Set Parts
2
1 7/8” X 11’ Leg
1
2 3/8” x 11’ 7” Top rail
1
1 7/8” x 13’ Third Leg
1
10’ Upright Ladder (Actual Length 12’)
1
Slide
1
Triple End with Sleeve
1
2 3/8” x 5’6” Toprail with Insert
9
Pieces Total
Hammer or Mallet
Shovel
Open End or Box Wrenches: 5/8”, 9/16”, ¾”
Digging Bar or Pick
Ratchet Handle & Sockets: 5/8”, 9/16”, ¾”, 17mm
Allen Wrench (Provided)
Marker Pen
Ladder
Tape Measure
Level
Cordless /Electric Drill w/ Following Bits: Phillips, 3/8”
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE BEGINNING
*Before digging, please obey local laws by notifying your local util
you are satisfied that the top rail is in the proper position, securely tighten the set
screws in the top sleeve of the ladder.
9. With the ladder still standing in its hole, situate the “A” frame end to the desired
position in the play area. Determine location of the “A” frame legs and mark the
holes. Move the legs out of the way and dig the holes. (Keep most of the hole to the
inside of the leg). Place the legs into the holes.
10. Measure from ab
Top Rail Assembly
Step 1: Slide the undrilled end of the longer Top Rail as far as it will go into the
Sleeve of the Triple End.
Step 2: Slide the Swing Hangers and tighten onto the Top Rail during the Top Rail
Assembly process. (Refer to spacing diagram and graphic found above)
Step 3: Insert and tighten (4) 3/8” x 3/8” set screws into each of the Triple End
Sleeves using Allen Wrench provided.
Step 4: Slide smaller diameter part of shorter top ra
Two piece Top Rail
Assembly
*Make sure to line up the set screws so they make a straight line
as show in the graphic above.
Step 1:
Step 2:
Step 3: