CommScope 864 FDH RESKIN KIT Installation Instructions Manual

© 2021 CommScope, Inc. All Rights Reserved Contents Installation Instructions TC-1504-IP Rev. A TC-1504-IP Rev A, July 2021 www.commscope.com 864 FDH RESKIN KIT (DRAFT 6) 1 General product information This installation instruction document describes the re-skin operation of the 864 cabinet. Images in this manual are for referenc ...

© 2021 CommScope, Inc. All Rights Reserved 5 Remove damaged cabinet 5.1 Open FDH with can wrench. Cabinet - Doors Closed Cabinet - Doors Open 5.2 Inspect the internal parts of the FDH. The swing frames need to be in good condition. Check Condition of Swing Frames and Center Post Tool List Note: If the riser is damaged ...

© 2021 CommScope, Inc. All Rights Reserved 5.4 Remove the rear attachment plates. (6 Pictures) Hardware Removal on Rear Side LHS Rear Plate Removal LHS Rear Plate Removal LHS Rear Plate Removal RHS Rear Plate Removal RHS Rear Plate Removal 5.5 Remove ground straps from cables and ground locate panel. (2 Pi ...

© 2021 CommScope, Inc. All Rights Reserved 5.6 Remove swing frame stops from cabinet shell. (2 Pictures) Upper Rear Swing Frame Stops Lower Swing Frame Door Stop 5.7 Remove bolts from base of cabinet shell. There are 4 bolts under the RHS swing frame and 4 bolts under the LHS swing frame. Cabinet Shell Bolt Removal 5.8 Remove the scre ...

© 2021 CommScope, Inc. All Rights Reserved 5.9 Apply tape to the swing frame latches to keep them in the open position. Tape on Swing Frame Latch 5.10 Remove the damaged cabinet shell by moving it toward the front and away from the swing frames. (2 Pictures). Cabinet Shell Removal Cabinet Shell Moved Away from Swing Frames and Center Po ...

© 2021 CommScope, Inc. All Rights Reserved 6 Install new cabinet shell New Cabinet Shell 6.1 If applicable install the new riser. Riser Kick Plate Removal 6.2 Remove swing frame stops from new cabinet shell at both the top and bottom. (2 Pictures) Top Swing Frame Stop Removal Bottom Swing Frame Stop Removal 6.3 Remove the cent ...

© 2021 CommScope, Inc. All Rights Reserved 6.4 Slide the new shell from the front and back over the swing frames. (2 Pictures) New Cabinet Shell in Position for Placement New Cabinet Shell Placed Over Swing Frames and Center Post 6.5 Attach center post to new cabinet shell and then reassemble cabinet in reverse order. (10 Pic ...

© 2021 CommScope, Inc. All Rights Reserved Re-attach Swing Frame Stops Re-install Ground Wires Re-attach Ground Wire at Cable Re-attach Ground Wire at Locate Panel 6.6 Transfer label information to new doors. Apply New Labels 6.7 Close and lock the cabinet doors. Close and Lock Cabine ...

© 2021 CommScope, Inc. All Rights Reserved 7 Trademarks and patents All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to CommScope products or services. C ...