Critical Link sCMOS Hardware Setup Manual

Text of Critical Link sCMOS Hardware Setup Manual

Copyright © 2007-2012, Critical Link LLC

Thank you for choosing the sCMOS Development Kit from Critical Link. The sCMOS Development Kit Hardware Setup Guide will introduce you to the hardware components of your development kit. Once completed, you should be able to follow the Application Quick Start Guide (located on the included DVD), which will guide you through your first image acquisition using the sCMOS camera. The sCMOS Development Kit contains the
Copyright © 2007-2012, Critical Link LLC Hardware Setup Figure 1 - sCMOS Camera Backpanel 1) Ensure that the Power “On/Off” toggle switch is in the “Off” position. (Identifier #2). 2) Insert the DC (4-pin) power connector into the “DC In” connector on the back panel of the sCMOS camera. (Identifier #1). 3) Note location of PWR Ok LED (Identifier #4). 4) Insert the Ethernet cable (CAT5) into the RJ45 receptacle (Identifier #3). Connect this cab
Copyright © 2007-2012, Critical Link LLC 7) The following steps were done with Win 7, but Win XP is similar. 8) Open the Network Connections dialog (shown below). The Network Connections may be found on the main screen or by selecting Control Panel -> Network and Internet -> Network Connections. 9) Select and ‘right-click’ the Lenovo USB NIC icon (highlighted in red) and then select “Properties” from the pop-up menu. 10) Select “Internet Protoc
Copyright © 2007-2012, Critical Link LLC sCMOS Development Kit Hardware Setup Guide For more details visit www.MityDSP.com

Critical Link Microcontrollers Owners Instructions: