Exmark LAZER Z AS Setup Instructions

Text of Exmark LAZER Z AS Setup Instructions

Page 1 of 5

109-6448 Rev. A Loose Parts Note: Use the chart below to verify that all parts have been shipped. 109-5736 Dealer Pack Part # Description Qty Use 323-6 98-5975 3290-357 Cap Screw, Hex 3/8-16 x 1 Washer, Belleville Nut, Hex Flange 3/8-16 8 8 8 Installing the Rollover Protection System (Roll Bar) 103-1309 Warranty Registration Form 1 Fill out and return to Exmark 103-2106 1-603511 Key, Exmark Ignition Key, Standard Ignition 1 1 Unit ignition 321

Exmark LAZER Z AS Page 2 of 5

109-6448 Rev. A FIGURE 2 FIGURE 4 FIGURE 3 NOTE: Be sure the spring disk washer cone is installed towards the head of the capscrew. 11. Locate the latch pin assemblies (pin and hairpin connected with a lanyard). 12. Insert a 1/2-13 x 3 1/4 capscrew (removed in step 5) into the bent tab washer on the lanyard of each pin assembly (Fig. 3). Note: Make sure the bent tab in the washer is towards the head of the bolt. 13. Lightly oil the inside surf

Page 3 of 5

109-6448 Rev. A Servicing the Battery The machine is shipped with a filled lead acid battery. 1. Unhook seat latch and tilt seat up to gain access to the battery. DANGER POTENTIAL HAZARD ♦ Charging the battery may produce explosive gasses WHAT CAN HAPPEN ♦ Battery gasses can explode causing serious injury. HOW TO AVOID THE HAZARD ♦ Keep sparks, flames, or cigarettes away from battery. ♦ Ventilate when charging or using battery in an enc

Page 4 of 5

109-6448 Rev. A FIGURE 5 FIGURE 6 Kawasaki 1. Remove air cleaner (with bracket attached) from seat frame. Keep air cleaner and mounting bracket together. 2. Loosely assemble large hose clamp (in dealer lit pack) onto the air cleaner intake hose. 3. Remove the protective tape from the carburetor intake. Slide the air cleaner intake hose onto the carburetor while aligning the four bracket mounting holes with the holes in the engine. 4. Assemble

Page 5 of 5

109-6448 Rev. A Servicing the Engine Refer to Engine Owner’s Manual. Servicing the Hydraulic Oil The machine is shipped with hydraulic oil in the reservoir. 1. Run the machine for approximately 15 minutes to allow any extra air to purge out of the hydraulic system. 2. Check hydraulic reservoir and if necessary fill the reservoir to the appropriate level with Mobil 1 15W-50 synthetic motor oil. 3. Replace hydraulic reservoir cap and tighten un

Exmark Lawn Mower Owners Instructions: