Supermicro Intel X12 Operation & User’s Manual
Read Online
Read the Supermicro Intel X12 Operation & User’s Manual online using the built-in PDF viewer.
Key Pages of Document
assumes no responsibility for any inaccuracies that may be contained in this document, and makes no commitment to update or to keep current the information in this manual, or to notify any person or organization of the updates. Please Note: For the most up-to-date version of this manual, please see our website at www.supermicro.com. Super Mi ...
This user's guide is written for system integrators, IT technicians and knowledgeable end users. It provides information and instructions on how to configure Intel Network Interface Card (NIC) settings on Supermicro's X12 DP/MP motherboards. About Intel Network Interface Card (NIC) Configuration This user's guide describes the settings of onboard Intel® LAN devices via the BIOS Setup utility supported by the Unifi ...
980 Rock Ave. San Jose, CA 95131 U.S.A. Tel: +1 (408) 503-8000 Fax: +1 (408) 503-8008 Email: [email protected] (General Information) [email protected] (Technical Support) Website: www.supermicro.com Europe Address: Super Micro Computer B.V. Het Sterrenbeeld 28, 5215 ML 's-Hertogenbosch, The Netherlands Tel: +31 (0) 73-6400390 Fax: +31 (0) 73-6416525 Email: sales@supermicr ...
Preface Chapter 1 Configuring Network Interface Card (NIC) Settings 1.1 Network Interface Card (NIC) Settings.................................................................................6 Preface ...
6
Chapter 1
Configuring Network Interface Card (NIC)
Settings
This chapter describes the settings of onboard Intel LAN devices via the BIOS Setup utility
supported by the Unified Extensible Firmware Interface (UEFI) driver.
1.1 Network Interface Card (NIC) Settings
Press during system boot to enter the BIOS Setup utility. Navigate to the Advanced
tab. Use the arrow keys to se ...
7
Note: If Onboard LAN1 Option ROM is set to EFI, all features for onboard LAN op-
tion ROM will be set to EFI by the EFI driver. Additionally, these features will become
unavailable except Onboard LAN1 Option ROM.
Onboard LAN1 Option ROM (Available when any NIC is detected by the system)
Use the arrow keys to select Onboard LAN1 Option ROM and press
8
For the changes to take effect, press during system boot to enter the BIOS Setup utility. Navigate to the Advanced
tab. The feature(s) for onboard Intel LAN device(s) will become available for configuration
as shown below.
...
9
Use the arrow keys to select the desired onboard LAN device as shown below.
Press
10 Blink LEDs This feature allows the user to set the LED blink duration (in seconds). The valid range is 0~15 (seconds). NIC Configuration Use the arrow keys to select NIC Configuration. ...
11
Press
