SuperATV Rear Windshield Installation Instructions Manual

Text of the manual

© 2016 SuperATV.com®. All Rights Reserved.

Rev IN-RWS-CA-DEF 8/1/2017 SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer. Rear Windshield for Can-Am Defender Seal Windshield (kit contents continue on following page) Thank You For Choosing 2753 Michigan Road • Madison, Indiana 47250

Start Seal here

Windshield (kit contents continued) Soak Seal in hot water before cutting or installing to increase flexibility. Bulb portion of Seal to always face towards vehicle Seal M6-1.0 x 20mm Lg. BHCS 14x M6-1.0 Nylock Nut 14x M6 Sealing Washer 14x Rubber must face Windshield when installing. Use hand tools only when assembling. Do no

(this side will face inside of machine)

- Install Large Brackets to locations shown in Windshield. Loosely secure with hardware shown. (driver side) (passenger side) M6 Nylock Nut Sealing Washer M6 x 20mm (top)

- Install to machines Cross Bar and secure Large Brackets with hardware shown.

Cross Bar (driver side) Large Bracket (passenger side) Cross Bar Large Bracket Bracket Sealing Washer M6 Nylock Nut M6 x 20mm each Bracket

- Install Small Brackets to top of Windshield with hardware shown.

- Install remaining Large Brackets. - Tighten all hardware completely. Sealing Washer M6 Nylock Nut M6 x 20mm qty (2) each Bracket Windshield Cleaning: - Do not use window cleaning fluids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, e

SuperATV’s® products are designed to best fit user’s ATV/UTV under stock conditions. Adding, modifying, or fabricating any factory or aftermarket parts will void any warranty

provided by SuperATV® and is not recommended. SuperATV’s® products could interfere with other aftermarket accessories. If user has aftermark

Other Automobile Accessories Manuals