STILFORD S2 Operation & User’s Manual

1. lnitial Setup After the initial assembly of the desk or if the display shows either of “E10, E16, E20 or E60”, press the button for 5 seconds until it shows , the desk will automatically move down to the lowest and rebound back up. The Initial Setup process is then finished and will display the lowest height ...

 Collision Force（ ）: Collision protection sensitivity; To navigate through the setup menu use the below buttons： Backspace key (back to previous menu) or Exit Setup Mode Tab switch Enter key (enter to next menu or confirm the current operation) If there is no numeric key pressed within 20 seconds the Setu ...

If you see the code not listed on above. Please turn off the desk for 3 minutes and turn on it again. If still not solve the problem, please contact 1300 office (1300 633 23) for spare parts or hardware replacement. 4 E16 Block protection 1. Message “E16” relates to the desk s stability and sensitivity and the anti ...

7. The default lowest height is 72cm. If you want to adjust lowest position to 67cm please follow below step. 1. Press " " button for 3-4 second until it shows "S - - " and flash. 2. Press " " button 1 time to go into the menu showing "Un". 3. Press "down" arrow button 4 times until it shows "SH". 4. Press " " button a ...