Prorack K602 Fitting Instructions Manual

Text of Prorack K602 Fitting Instructions Manual

Fitting Instructions for Basic Carrier

x 4 x 4 x 4 x 4 x 4 x 1 x 4 Revision No: 8H 1

MAX kgs (lbs)

W/P WHD Peugeot 4008, 5dr SUV 12-+ EU 50 kgs (110 lbs) 50 kgs (110 lbs) Mitsubishi ASX, 5dr SUV 10-+ EU 50 kgs (110 lbs) 50 kgs (110 lbs) ASX, 5dr SUV 10-+ CN 50 kgs (110 lbs) 50 kgs (110 lbs) ASX, 5dr SUV Aug 10-+ NZ 50 kgs (110 lbs) 50 kgs (110 lbs) ASX, 5dr SUV Aug 10-+ AU 50 kgs (110 lbs) 50 kgs (110 lbs) Outlander Sports, 5dr SUV 11-+ US 50 kgs (110 lbs) 50 kgs (110 lbs) Citroen C4 Aircross, 5dr SUV 12-+ EU 50 kgs (110 l

Prorack K602 4008, 5dr SUV 12-+ (EU)

-210mm 490mm - 875mm 820mm - -8 -1/4ths" 19 5/16ths" - 34 7/16ths" 32 5/16ths" - ASX, 5dr SUV 10-+ (EU) -210mm 490mm - 875mm 820mm - -8 -1/4ths" 19 5/16ths" - 34 7/16ths" 32 5/16ths" - ASX, 5dr SUV 10-+ (CN) -210mm 490mm - 875mm 820mm - -8 -1/4ths" 19 5/16ths" - 34 7/16ths" 32 5/16ths" - ASX, 5dr SUV Aug 10-+ (NZ) -210mm 490mm - 875mm 820mm - -8 -1/4ths" 19 5/16ths" - 34 7/16ths" 32 5/16ths" - ASX, 5dr

S Max, 5dr MPV Jun 06-+ (EU)

-90mm 650mm - 1020mm 980mm - -3 -9/16ths" 25 9/16ths" - 40 3/16ths" 38 9/16ths" - S Max, 5dr MPV Jun 06-+ (CN) -90mm 650mm - 1020mm 980mm - -3 -9/16ths" 25 9/16ths" - 40 3/16ths" 38 9/16ths" - 4

First Time Installation

G Remove parts from inside the package and check. Contact your dealer if any parts are missing or damaged. G This kit fits type A, B, C and D. G These instructions show type A crossbar fitted. They also apply to type B, C and D. G Use keys to remove covers. 5

Prorack K602 G Use hex screwdriver to reverse adjusting

screw 10 turns. G Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment method. G Ensure each end of the crossbar is adjusted equally. G Set bars to length (revert to rear of these instructions). G Please check the front of this manual for information relating specifically to your vehicle. 6

G Tighten adjusting screw to 2.5 Nm (1.8 ft lb)

hand tight. G Remove plastic clamp block by gripping bar leg with fingers and push firmly with thumbs until clamp block drops out behind leg. G Select plastic internal block (from fitting kit) and insert into foot. G Repeat for all legs. 7

G Fit rubber pad (supplied with crossbar) to

foot. G Make sure the pad fits into the holes underneath the foot. Fitment G Open or remove fixed-point covers. G Fitment to Ford Focus ONLY. G Remove fixed-point covers by turning the plastic screw with flat-head screw driver (1). G Remove sealant (2) to reveal plastic screw (3). Caution: Do not damage the screw head. G Remove the plastic screw (3) with a Philips-head screw driver. 8

Prorack K602 G Select grubscrews and screw into the

vehicle's fixed points. G A = Ford S-Max B = Not applicable unless advised C = Mitsubishi ASX / Outlander Sport / Ford Focus / Citroen C4 Aircross / Peugeot 4008 G Do not over tighten. G Repeat for all four positions. G Place load support over grubscrew as shown. 9

G Place crossbar foot over grubscrews.

Attention: G Fitment for Mitsubishi ASX / Outlander Sport / Citroen C4 Aircross / Peugeot 4008 G Rubber pad should be tucked inside the roof step as shown G Tighten the plastic knob. The side with the nut showing should be facing up. 10

G Ensure the plastic knob is in the position

shown when fully tightened. G Repeat for all four positions. G Check crossbar is securely attached to the vehicle. G Use keys to fit and lock covers CAUTION: Recheck all fasteners immediately after a load is applied to the crossbars. Regularly check screws are tight. 11

G Clean the car roof and surfaces of the

product that will be in contact with the car roof. G Follow the fitting instructions for fitting the product to your vehicle. Make sure all steps are carried out in order. G Set crossbars a minimum distance of 700mm (27 1/2") apart where no other distance is specified in the fitting instructions. This is especially important when carrying long loads. G Check unit is securely attached

G Check and replace worn out or defective

parts. G Keep the product clean and maintained. G Never drive into a car wash with the roof rack system fitted. G Lubricate locks and adjusting screws at regular intervals. G Remove the products from the vehicle when not in use. Make sure all loose parts are stored safely. G Yakima Australia Pty Ltd 17 Hinkler Court Brendale QLD 4500 AUSTRALIA www.whispbar.com www.whispbar.com.au www.whispbar.co

WARRANTY & DISCLAIMER

Yakima Australia Pty Ltd ABN 58 154 440 221 17 Hinkler Court, Brendale QLD 4500 Tel: 0800 4776 722 (NZ) or 1800 143 548 (AU) Email: [email protected] or [email protected] Where the product is supplied to the customer for other than business purposes within the meaning of section 43 of the New Zealand Consumer Guarantees Act 1993, the provisions of that Act shall apply. It is important that anyone who fits

Alternately, you can write to Yakima at 17 Hinkler Court, Brendale QLD Australia 4500 in order to make a claim under your

warranty. Upon contacting Yakima directly, you should explain as fully as possible the defect. A Yakima representative will provide you with appropriate instructions for returning the product together with a copy of the original purchase invoice or receipt to Yakima. The costs and expenses associated with making a claim under your

Prorack Automobile Accessories Owners Instructions: