Progress PVS1552 Operation & User’s Manual

Text of Progress PVS1552 Operation & User’s Manual

Before first use

13 Daily use 14 Hints and tips 16 Care and cleaning 17 Troubleshooting 21 Technical information 25 Subject to change without notice. VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.progress-hausgeraete.de/support SAFETY INFORMATION Before the installation a

• Children shall not carry out cleaning and user maintenance

of the appliance without supervision. General Safety • This appliance is intended to be used in household and similar applications such as: – farm houses; staff kitchen areas in shops, offices and other working environments; – by clients in hotels, motels, bed & breakfast and other residential type environments. • Do not change the specification of this appliance. • The operating wate

Do not use the appliance before

installing it in the built-in structure due to safety manner. • Follow the installation instructions supplied with the appliance. • Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear. • Do not install or use the appliance where the temperature is less than 0 °C. • Install the appliance in a safe and suitable place that meets installation requirements. Electr

Progress PVS1552 WARNING! Risk of injury.

• Concerning the lamp(s) inside this product and spare part lamps sold separately: These lamps are intended to withstand extreme physical conditions in household appliances, such as temperature, vibration, humidity, or are intended to signal information about the operational status of the appliance. They are not intended to be used in other applications and are not suitable for household room illumination. • T

Upper spray arms

2 Lower spray arm 3 Filters 4 Rating plate 5 Salt container 6 Air vent 7 Rinse aid dispenser 8 Detergent dispenser 9 Cutlery basket 10 Lower basket 11 Upper basket CONTROL PANEL 1 2 3 4 5 6 1 On/Off button/Reset button 2 Delay start button 3 Indicators 4 Programme buttons 5 Extra power button 6 AUTO programme button 6 Progress

Rinse aid setting indicator. It is on when you set the released quantity of rinse

aid. Refer to "Basic settings". Salt indicator. It is on when the salt container needs refilling. Refer to "Before first use". Machine Care indicator. It is on when the appliance needs internal cleaning with the Machine Care programme. Refer to "Care and cleaning". Drying phase indicator. It is on when a programme with the drying phase is sele

Progress PVS1552 Type of load

Degree of soil Programme phases Options 30min • Crockery • Cutlery • Fresh • Wash 50 °C • Intermediate rinse • Final rinse 45 °C • AirDry • Extra power Pre Rinse • All types of loads • All de‐ grees of soil • Prewash Options are not applicable to this programme. 90min • Crockery • Cutlery • Pots • Pans • Normal • Lightly dried-on • Wash 60 °C • Intermediate rinse •

8.0 - 10.7

0.683 - 1.047 120 - 170 Machine Care 7.4 - 8.9 0.396 - 0.484 60 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values. 2) In accordance with the 1016/2010 regulation 3) In accordance with the 2019/2022 regulation Information for test institutes To receive the necessary in

You can change the basic settings in

setting mode. When the appliance is in setting mode, the indicators on the control panel represent available settings. For each setting, a dedicated indicator flashes: 1 3 2 4 5 The water softener The water softener removes minerals from the water supply, which would have a negative effect on the washing results and on the appliance. The higher the content of these minerals, the harder your water is. Water hardness is m

Progress PVS1552 between the final rinse and the

programme end. Water softener level Amount of water (l) 1 250 2 100 3 62 4 47 5 25 6 17 7 10 8 5 9 3 10 3 In case of the high water softener setting, it may occur also in the middle of the programme, before the rinse (twice during a programme). Regeneration initiation has no impact on the cycle duration, unless it occurs in the middle of a programme or at the end of a programme with a short drying phase. In that cases, the r

AirDry is automatically activated with all

programmes other than Pre Rinse. CAUTION! Do not try to close the appliance door within 2 minutes after automatic opening. This can cause damage to the appliance. CAUTION! If children have access to the appliance, we advise to deactivate AirDry. The automatic opening of the door may pose a danger. Key tones The buttons on the control panel make a click sound when you press them. You can deactivate this sound. Sett

The new setting is saved.

• The appliance returns to the setting selection. 5. Press and hold simultaneously 30min and ECO for about 3 seconds to exit setting mode. The appliance returns to the programme selection. The saved settings remain valid until you change them again. BEFORE FIRST USE 1. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener. 2. Fill t

How to fill the rinse aid

dispenser B C D A CAUTION! Only use rinse aid designed specifically for dishwashers. 1. Press the release element (A) to open the lid (B). 2. Pour the rinse aid in the dispenser (C) until the liquid reaches the marking "FILL". 3. Remove the spilled rinse aid with an absorbent cloth to prevent excessive foam formation. 4. Close the lid. Make sure that the lid locks into position. Fill the rinse aid dispenser when the indicator (D)

Extra power is not applicable to

this programme. 2. Close the appliance door to start the programme. How to activate Extra power 1. Select a programme. 2. Press Extra power. The light related to the button is on. Extra power is not a permanent option and must be activated every time before you start a programme. It is not possible to activate or deactivate Extra power while a programme is running. Activating Extra power increases the water and energy consu

End of the programme

When the programme is complete, the Auto Off function switches the appliance off automatically. All buttons are inactive except for the on/off button. HINTS AND TIPS General Follow the hints below to ensure optimal cleaning and drying results in daily use and to protect the environment. • Washing dishes in the dishwasher as instructed in the user manual usually consumes less water and energy than washing dishes by hand. • Load the

Progress PVS1552 increased quantity of salt in the water

might result in rust on cutlery. What to do if you want to stop using multi-tablets Before you start using separately detergent, salt and rinse aid, complete the following steps: 1. Set the highest level of the water softener. 2. Make sure that the salt and rinse aid containers are full. 3. Start the 30min programme. Do not add detergent and do not put dishes in the baskets. 4. When the programme is completed, adjust

results. It removes limescale and grease

buildup. When the appliance senses the need for cleaning, the indicator is on. Start the Machine Care programme to clean the appliance interior. How to start the Machine Care programme Before starting the Machine Care programme, clean the filters and spray arms. 1. Use a descaler or a cleaning product designed specifically for dishwashers. Follow the instructions on the packaging. Do not put dishes in the baskets.

Progress Dishwasher Owners Instructions: