PrimaLuna EvoLution Series Quick Start Manual

Text of PrimaLuna EvoLution Series Quick Start Manual

Table of Contents

Thank You! 3 Specifications 4A Warning - Package Contents - Initial Setup 5 Front and Back Panel Inputs, Outputs, Controls & Remote Function 6AB Remote Control 7 Headphone Output Connection 8 Home Theater Through 9 PhonoLogue Chassis - PhonoLogue Board 10 Tube Basics 11 Mains Fuse Protection - Electronic Protection 12 Internal Power Stage Fuses – How To Check 13 Troubleshooting 14 Warranty Information 15 PrimaLuna Nam

We want to thank you for choosing our first PrimaLuna EVO Hybrid Integrated Amplifiers as the heart of your music system.

The EVO Hybrid Integrated Amplifier is the first member of our new family of high-quality hybrid products. The designers and builders of the PrimaLuna equipment have a long history in high-end audio. In this new project, we have collaborated with Floyd Design, the solid-state design arm of our parent compan

Model EVO 300 Hybrid Integrated Amplifier

Power 8 Ohm >100 Watts per channel (typical 115 Watts) Power 4 Ohm >150 Watts per channel (typical 170 Watts) Frequency Response 10 Hz – 80 kHz +/- 3 dB THD < 0.2% 100W @ 8 Ohm S/N Ratio -105dB (A-Weighted) Input Impedance 34 kOhm Input Sensitivity 415 mV Total Gain (Pre + Power Amp) 37.2 dB (7dB + 30.2dB) Power Consumption 99 Watts (no signal in); 645W@4R Weight Net weight: 59.

To prevent serious injury, electrical shock or fire:

 Do not operate with the bottom plate removed. Keep away from rain and moisture.  Disconnect the ac mains cable before changing fuses or tubes.  Do not replace fuses with any fuse other than the same type and rating as used by the factory.  Do not replace tubes without reading instructions.  Do not replace fuses or tubes if you have any doubt about your ability t

Front Panel Outputs, Controls & Remote Function

PrimaLuna front panels are made from machined aluminium, matching the black/blue metallic chassis. The volume is controlled with the knob on the left, and source selection is on the right. The remote control can also deal with both volume and source selection. Your sources are labelled AUX 1, AUX 2, etc. (no functional differences between these) and eventually HT. The headphone output is o

Back Panel Inputs, Outputs

At the rear panel, you will find your inputs, eventually the HT Pass-Thru, the speaker terminals, Tape Out and Sub Out. Attach the (+) from your loudspeaker to the (+) terminal on the amplifier and the (-) from your loudspeaker to the (-) terminal.

Attention! Due to increasingly stringent safety

measures, the remote control may arrive without batteries installed. The functions of the EVO Hybrid Integrated Amplifier Remote Controls are self-explanatory. It controls source selection, volume & mute functions. The remote will also manage the essential functions of the PrimaLuna CD players. The EVO Hybrid Integrated Amplifier Remote Controls have two high-quality silicon

Headphone Output Connection

Owners of a PrimaLuna EVO Hybrid Integrated Amplifier also own one of the best headphone amps available. At the flip of a switch! On the right side of the front panel, you find the output connector for your headphones, while just behind the front panel on the right side, you find the switch to select for loudspeakers (LS) or headphones (HP). Headphones are simply small speakers that require less power. Most in

PrimaLuna Amplifier Owners Instructions: