Datalogic QuickScan QS2500 Product Reference Manual

Text of the manual

Datalogic Scanning, Inc.

959 Terry Street Eugene, Oregon 97402 Telephone: (541) 683-5700 Fax: (541) 345-7140 An Unpublished Work - All rights reserved. No part of the contents of this documentation or the procedures described therein may be reproduced or transmitted in any form or by any means without prior written permission of Datalogic Scanning, Inc. or

Product Reference Guide

1 Table of Contents Installation ......................................................................................... 1 Keyboard Wedge .........................................................................................1 Wand Emulation ...............................................................

Standard 2 of 5 .........................................................................................54

Code 16K .................................................................................................56 PDF417 ....................................................................................................57 Italian PharmaCode .....

Product Reference Guide

1 Installation Complete the following steps for the appropriate interface. Keyboard Wedge 1. Turn off the terminal or computer. 2. Disconnect the keyboard cable from the back of the terminal or computer. 3. Connect the QS2500 to the terminal or computer using the appro- priate interface cable. 4. Turn the te

Plug the USB cable into the terminal or computer.

IBM 1. Turn off the terminal or computer. 2. Connect the appropriate interface cable to the terminal or com- puter. 3. Turn the terminal or computer on. NOTE If the QS2500 does not operate, turn off the terminal or computer immediately and check all connections. If necessary, go through the ab

Product Reference Guide

3 Programming the QS2500 To program the QS2500, you must scan a series of programming bar codes in the correct order. The inside back cover of this manual contains a table of alphanumeric bar codes needed to program the various options. To program each option: 1. Scan the Start Program bar code above the lis

Resetting the QS2500

To return all QS2500 option settings to the factory defaults, scan the fol- lowing two bar codes, in the order shown: Interfaces The QS2500 supports Keyboard Wedge, RS-232, Wand Emulation, IBM and USB interfaces. The correct interface cable is included for the scanner interface type you ordered. Keyboard Wedge As a keyboard inte

Product Reference Guide

5 Function Key: When this option is enabled, the QS2500 outputs bar code ASCII values from 01hex to 1Fhex as function-key presses in your applica- tion. See the table of ASCII codes In Appendix C on page 66. Option Bar Code Option Alphanumeric Entry Keyboard Type IBM AT, PS/2 00* Reserved 01 - 06 Keyboard La

Other Barcode Reader Manuals