DAVIS DriveRight OBD II Installation Manual

Text of the manual

FCC Part 15 Class B Registration Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation. This equipment generates, uses, and can radiate radio frequency

This manual provides instructions and information necessary to install

DriveRight OBD. DriveRight OBD plugs into your vehicle’s OBDII (On-Board Diagnostics II) port for a very quick and easy installation. Note: DriveRight OBD only functions in vehicles equipped with a compatible OBDII port. See “Appendix 1: OBDII Compatibility” on page 1

Additional DriveRight Documentation

Refer to the following documents for information on configuring and using your DriveRight: • The DriveRight User’s Guide included with your unit. • The on-line help in the DriveRight software. • The DriveRight FMS User’s Manual located in an Adobe Acrobat PDF file in your DriveRight pr

Installations using Adapter Cable Digital Inputs

If you are using the adapter cable digital inputs in your installation, the following additional tools and other items may also be required: • Crimping Tool • Multimeter • Fuse Tap - Required to obtain +12 V from the fuse panel. Planning the Installation The installation for DriveRight OBD is very simp

The diagram below provides an overall picture of DriveRight OBD

wiring. Procedure 1: Connect OBD Cable to OBDII Port. 1. Locate the OBDII port in the vehicle. The OBDII port will be located within 3 feet of the steering wheel, usually within the general area indicated by the dotted line in the illustration below. The port should be easily ac

Look in the follow areas if you have trouble finding the OBDII port:

• Under the dash • In front of the passenger seat • Behind the ash tray • Behind a small access panel in the dash • In or around the center console 2. Plug the OBD cable into the port. Note: The indicator light blinks three times when first plugged in, then blinks twice per seco

1. If you are installing a DriveRight 600 OBD but not using the digital

inputs, go to Step 10 of this procedure. 2. Butt splice the red fuse holder to the red wire from the adapter cable. 3. Tap the red fuse holder to an unswitched +12 V source using the in- line splice provided with your DriveRight or using a fuse tap con- nector (not included) appropriat

Other Automobile Accessories Manuals