DAVIS Wireless Temperature/Humidity Station Installation Manual

Installation Manual For Vantage Pro2™ and Vantage Pro2 Plus™ The Wireless Temperature/Humidity Station, referred to as the Temp/Hum Station in this manual, is for use with Wireless Vantage Pro2 weather stations. It is not com- patible with original Vantage Pro wireless weather stations. Owners of original Van- tage ...

In addition to the hardware provided, you will need some or all of the following materials: • Small phillips head screwdriver • Adjustable wrench or 7/16" wrench • Ballpoint pen or paper clip (small pointed object of some kind) • Drill and 3/16" (5 mm) drill bit (if mounting on a flat, vertical surface) Installation Steps For ease o ...

ened, lift the mounting bracket away from the radiation shield. 4. Rotate the mounting bracket and replace it on the radiation shield. 5. Fasten the mounting bracket in place using the three long screws as shown in the illustration right. Applying Power 1. Locate the SIM Shelter and open it by pushing the latch away ...

tom right hand corner of the SIM board. Take care to carefully dress the cable through the black rubber grommet on the bottom right hand side of the shelter. Also, dress the cable through the cable clamp by first removing the screw con- necting it to the shelter, dressing the cabl ...

Setting Console Station ID on the Console 1. Put your console into Setup Mode — press and hold DONE and press the DOWN arrow (-). The console will show you Screen 1: Transmitters. You should see the words: “RECEIVING FROM...” and “STATION NO.” followed by the tra ...

you are not receiving the sensor readings on the console go the the next section, “No Communication with Temp/Hum Station”. 3. Close the SIM Shelter cover. See page 4. 4. Go on to “Choosing a Location for the Temp/Hum Station” on page 7. No Communication with Temp/Hum Sta ...

Consider the following factors as you choose a location: • Do not mount the station near any source of cold or heat that might distort tem- perature measurements. • The station’s radiation shield works best in a location with a steady breeze. Mount it away from fences, buildings, trees, or other obstructio ...

mounted on the pole. 3. Next, install the SIM Shelter. While holding the shelter against the pole, place a U-bolt around the pole and through the two holes on at the top of the shelter. 4. Place a flat washer, a lock washer and a hex nut on each of the bolt ends. 5. Using an ...

approximately 2" (50 mm) apart. Use a carpenter’s level to ensure the holes will be level. 3. Drill two more holes 7-1/32" below the upper holes. 4. Insert the 1/4" x 1-1/2" lag screws through the flat washers, and through the holes at the top of the shelter into the post. U ...

be reduced if the shield plates become dirty. Clean the surfaces of the shield plates periodically with a damp cloth. • Keep areas between the shield plates free of debris that may obstruct air flow. Examples are leaves, twigs, webs, nests. • DO NOT rem ...