ZKTeco MA500 Installation Manual & User Manual

Thank you for purchasing this product. Before using the unit, please read this manual carefully to avoid any unnecessary damage. The correct usage of this unit ensures fast and effect performance. No written consent will be given by our company, or individual representing our company to copy the content of this manual in ...

Installation Guide 1. Equipment Installation ……………………………………………………………………………………………………………………………….…i 2. Structure and Function …………………………………………………………………………………………………………� ...

i 1. Equipment Installation Wall mount installation (5)Fix the device to the back plate. (6)Tighten the screws at the bottom of the device. (4)Fix the back plate on the solid wall according to the mounting paper. Note: If it is not possible to drill on the hollow wall, please select a plastic box instead of iron plate ...

ii 2. Structure and Function 3. Lock Connection Access Control System Function: (1)If a registered user is verified, the device will trigger the lock control relay to open the door. (2)The door sensor will detect the on-off state. If the door is unexpectedly opened or improperly closed, the alarm relay will be trigger ...

iii (I) Share power with the lock: NC LOCK + - - - + DC 12V NO LOCK + - - - + DC 12V FR107 FR107 White SEN Black GND Gray BUT Blue NO Red COM Yellow NC Orange AL- Orange AL+ Red +12V Black GND Red +12V Black GND White SEN Black GND Gray BUT Blue NO Red COM Yellow NC Orange AL- Orange AL+ (II) Separate power for both d ...

iv 4. Connected with Other Parts 5. Connected with Power The device supports standard Wiegand output, it is able to connect with various third party access control panel, which has Wiegand input. (1)Do not exceed 90m (meters) distance between the Device and Access Control Lock OR Card reader. (In the case ...

v 7. Communication There are two modes that the PC software communicate and exchange information with the device: RS485 and TCP/IP, and supports remote control. (1) RS485 Mode: Please use specified RS485 wire, RS232/485 active converter, which consists of bus-type wiring. If the communication wire is longer than ...

vi Diagram of the device connect to controller as below: Set the 485 address (device number) by ZKAccess3.5 software. (2) TCP/IP Mode: (A)Cross-Over cable: the device connects to PC directly (B)Straight-through: The device and PC are connected to Switch. ...

1 Instructions Recommended Procedure: Step 1: Install the device and power on. Step 2: The administrator password is authenticated and changed. Step 3: Register users' fingerprints, cards, or passwords. Step 4: Configure access control parameters, including configuring the unlocking duration, authentication mode, stealth mode, door status ...