Zircon MetalliScanner x8 Manual 

ENGLISH Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installing the Batteries . . . . . . . . . . . . . . . . . . . . . . . . 4 Powering ON/OFF the Tool . . . . . . . . . . . . . . . . . . ...

Battery Strength Indicator Transflective Backlit Display Numeric Depth Indicator Metric Unit Metal Type Indicator Sensitivity Level Relative Signal Strength Indicator Sensitivity Button CAL Button Pivoting Handle Attachment Hatch Lanyard Loop Sound Button Battery Door (back of tool) OVERVIEW The MetalliScanner ® ...

This tool requires 3 new AAA (LR03) batteries. To install or replace the batteries, locate the battery door on the lower backside of the tool. Using a Phillips size #1 screwdriver, unscrew the screw and lift up the battery door compartment. Remove old batteries, if needed, and insert three new AAA batteries, matching the positive ...

In Low Sensitivity, the target needs to be very large or fairly close to the surface before an indication is given. This sensitivity level is best suited for environments with high metal content. Always perform the initial scans in the Low Sensitivity default setting. If no metal is found after ...

on the dimpled area and lift up gently. Align the handle so that the button on the tip of the handle is flush against the hatch door. Push down gently until it snaps securely in place. To remove the handle, hold the tool down with one hand and pull the base of the handle upwards. To attach the option ...

with the strongest signal, the Target icon will display. If the Sound is on, the tool will also beep intermittently when you are over the center of the target. 10. When the center of a target has been identified, you can mark the target using t ...

locator’s readings. • Avoid wearing watches and jewelry. • Use the handle attachment and/or optional extension pole. Tool is unable to calibrate and shows the letters “ERR” in the Numeric Depth Indicator area of the display. • There is too much metal near the tool’s calibrati ...

Sistema de marcación (parte posterior de la herramienta) Indicador de potencia de la batería Pantalla trans reflectante con iluminación de fondo Indicador numérico de profundidad Unidad métrica Indicador de tipo de metal Nivel de sensibilidad Indicador de potencia relativa de la señal Botón de sensibilidad Botón C ...

Este instrumento trabaja con 3 baterías AAA (LR03) nuevas. Para colocar o cambiar las baterías, ubique la tapa del compartimiento de las baterías en la parte inferior y posterior del instrumento. Con un destornillador de estrella No. 1, desatornille el tornillo y levante la tapa del compartimiento de las baterías. Re ...