Shuttle AB49 Operation & User’s Manual

Intel Pentium 4/Celeron 478-pin Processor with 400/533 MHz FSB Based DDR MAINBOARD User's Manual ...

Intel Pentium 4/Celeron 478-pin Processor with 400/533 MHz FSB Based DDR Mainboard Manual Version 1.0 Copyright Copyright© 2003 by Shuttle® Inc. All Rights Reserved. This publication, including all photos, illustrations, and software, is protected under interna- tional copyright laws, with all rights reserved. Reproducing any of ...

Shuttle mainboards have been via the EMI test in terms of series of regulations: EN55022/ CISPR22/AS/NZS3548 Class B, EN55024 (1998/AS/NZS), EN4252.1 (1994), EN61000, ANSI C63.4 (1992), CFR47 Part 15 Subpart B, and CNS13438 (1997). The items tested are illus- trated as follows: (A) Voltage: AC 110V/60HZ & AC 23 ...

(F) Notices for Assembling Computers: 1. Cases should be made of iron or other metal that has good electric conductivity. 2. Cylinders in a case should be made of metal, and as having a mainboard mounted in a case, make sure screws are all utilized and fastened on a mainboard. 3. An I/O shielding should be contacted with I/O m ...

WHAT'S IN THE MANUAL.................................................................... 5 Quick Reference ............................................................................................... 5 About This Manual ........................................................................................... 5 1 INTRODUCTION....................... ...

3.2 JUMPER SETTINGS ................................................................................. 22 JUMPERS & CONNECTORS GUIDE.................................................... 23 Jumpers Clear CMOS Setting (JP1) ................................................................... 25 BIOS Flash Protection Setting (JP2) .......................... ...

Audio CD_IN Connectors (CDIN1/CDIN2) ............................................. 33 IR Header (IR1)...................................................................................... 34 3.3 SYSTEM MEMORY CONFIGURATION ..................................................... 35 1. INSTALL MEMORY ........................................................ ...

LOAD OPTIMIZED DEFAULTS ................................................................. 63 SET SUPERVISOR/USER PASSWORD................................................... 64 SAVE & EXIT SETUP................................................................................ 65 EXIT WITHOUT SAVING ......................................................... ...

Quick Reference Hardware Installation >> Step-by-Step ................................................ Page 11 Jumper Settings >> A Closer Look....................................................... Page 22 Drivers/Software Utilities >> How to Install ......................................... Page 36 BIOS Setup >> How to Configure...................... ...

1 INTRODUCTION 1.1 To Different Users First-Time DIY System Builder Welcome to the DIY world! Building your own computer system is not as diffi- cult as you may think. To make your first computer DIY experience successful, right from the start, we have designed the 3.1 Hardware Installation section in a step-by-step fashion for all the first-time DIY s ...