Sharp CD-BK3020W Operation Manual

Text of Sharp CD-BK3020W Operation Manual

MANUAL DE MANEJO

SHARP CORPORATION MODEL MODÈLE MODELO CD-BK3020W MINI COMPONENT SYSTEM MINI-CHAÎNE SISTEMA MINI CD-BK3020W Mini Component System consisting of CD-BK3020W (main unit) and CP- BK3020 (speaker system). Mini-chaîne CD-BK3020W composée de CD-BK3020W (appareil principal) et de CP- BK3020 (enceintes acoustiques). Sistema mini CD-BK3020W que consta de CD-BK3020W (aparato principal) y CP-BK3020 (sistema de altav

- Introduction / Special Notes -

Introduction Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read this manual carefully. It will guide you in operating your SHARP product. Special Notes z When the ON/STAND-BY button is set at STAND-BY position, mains voltage is still present inside the unit. When the ON/STAND-BY button is set at STAND-BY posi- tion, the unit ma

- Accessories / Contents -

Accessories Please confirm that the following accessories are included. Note: Only the above accessories are included. Contents Page „ General Information Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Controls and Indicators . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 6 „ P

Sharp CD-BK3020W - Precautions -

Precautions „ General z Please ensure that the equipment is positioned in a well ventilated area and ensure that there is at least 10 cm (4") of free space along the sides, top and back of the equipment. z Use the unit on a firm, level surface free from vibration. z Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers,

- Controls and Indicators -

Controls and Indicators „ Front panel Reference page 1. Disc Tray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 2. Timer Set Indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 3. On/Stand-by Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 4. Tape 2 Cassette Compartment .
- Controls and Indicators - Controls and Indicators (continued) „ Display 1. Extra Bass Indicator 2. FM Stereo Mode Indicator 3. FM Stereo Receiving Indicator 4. Karaoke Mode Indicator 5. CD Repeat Play Indicator 6. CD Pause Indicator 7. CD Play Indicator 8. Tape 2 Record Indicator 9. Tape Reverse Mode Indicator 10.Disc Number Indicators 11.Timer Play Indicator 12.Memory Indicator 13.Tape 2 Reverse Play Indicator 14.Tape 1
- Controls and Indicators - „ Remote control Reference page 1. Remote Control Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 2. Echo Level Up and Down Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . 22 3. Karaoke Mode Button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 4. Disc Number Select Buttons . . . . . . . . . . . . . . . . . . . . . . . . . .

Preparation for Use

- System Connections - System Connections AM loop aerial Right speaker Left speaker VCR, DVD, etc. not supplied FM aerial To a wall socket (See page 9.)
Preparation for Use - System Connections - „ Aerial connection Note: Placing the aerial on the unit or near the AC power lead may cause noise pickup. Place the aerial away from the unit for better reception. Installing the AM loop aerial: External FM aerial: Use an external FM aerial if you require better reception. Consult your dealer. Note: When an external FM aerial is used, disconnect the supplied FM aerial wire. „ Speaker connection Ma
Preparation for Use - System Connections - System Connections (continued) „ Placing the speaker system The left and right speakers have individual shapes. For best performance, place the speakers according to the diagram below. Bi-amp system: Each speaker unit has a built-in subwoofer (low frequency range) which is driven sep- arately from the super tweeters, woofer and tweeter (mid-to-high frequency range). Two independent amplifiers which h
Preparation for Use - System Connections / General Control - „ Setting the FM/AM span selector The International Telecommunication Union (ITU) has established that member coun- tries should maintain either a 100 kHz or a 50 kHz interval between broadcasting fre- quencies of FM stations and 10 kHz or 9 kHz for AM station. The illustration shows the 50/9 kHz zones (regions 1 and 3), and the 100/10 kHz zone (region 2). Before using the unit, se
Preparation for Use - Remote Control - Remote Control „ Battery installation Precautions for battery use: z Replace all old batteries with new ones at the same time. z Do not mix old and new batteries. z Remove the batteries if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage. Caution: z Do not use rechargeable batteries (nickel-cadmium battery, etc.). z Installing the batteries in

- Sound Control -

Sound Control „ Volume control Main unit operation: When the VOLUME control is turned clockwise, the volume will increase. When it is turned anti-clockwise, the volume will decrease. Remote control operation: Press the VOLUME button to increase the volume and the VOLUME button for decreasing. „ Bass control When the power is first turned on, the unit will enter the extra bass mode which emphasises the ba

Sharp CD-BK3020W - Setting the Clock -

Setting the Clock In this example, the clock is set for the 24-hour (0:00) display. Note: The "CLOCK" or time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit. Readjust the clock as follows. To readjust the clock: Perform "Setting the Clock" from the beginning. If the time display is flashing, step 3 (for selecting the 24-hour or 1

Sharp CD-BK3020W - Listening to a CD (CDs) -

Listening to a CD (CDs) This system can play audio CD-R and CD-RW discs just as CD discs, but cannot per- form recording. (However, some CD-R and CD-RW discs may not be played.) Continued to the next page 1 Press the ON/STAND-BY button to turn the power on. 2 Press the CD button. 3 Press the OPEN/CLOSE button to open the disc tray. 4 Place the CD(s) on the disc tray, label side up. When loading a third
- Listening to a CD (CDs) - Listening to a CD (CDs) (continued) To interrupt playback: Press the button on the remote control. To resume playback from the same point, press the button. To stop playback: Press the button. To remove the CDs: Whilst in the stop mode, press the OPEN/CLOSE button. The disc tray will open. Remove the two discs. Then, press the DISC SKIP button to rotate the disc tray and remove the remaining disc. Af

Sharp Stereo System Owners Instructions: