Worker IN 2636 Operation & User’s Manual

IN 2636 Scooter WORKER Rodez *The photo is for illustration purposes only. Colour and design may wary, depending on the model. ...

SAFETY PRECAUTIONS ........................................................................................................................ 3 ASSEMBLY INSTRUCTIONS ................................................................................................................. 4 Wheel Assembly ................ ...

OR PERFORMING MAINTENANCE ON THIS SCOOTER. IMPORTANT INFORMATION  Suitable for children over 5 years of age.  Check and tighten the bolts and screws before every ride.  Make sure all components are functioning properly before every ride. Check also the correct setting of the steering system.  Maintain inflation of the tires to no more than the maximum inflation marked on ...

 Never ride the scooter in damp or rainy weather. Wet surfaces may increase braking distance.  Never tow other vehicles or children on skates or skateboards behind the scooter.  Do not ride at night or in lowered visibility conditions.  Always wear shoes when riding this scooter. Do not wear open shoes.  Give pedestrians the right-of-way. Don't ride too close to pedestrians.  Avoid haz ...

the stem bolt by using a wrench. Make sure the stem is installed below the maximum height mark. (c) Fork tube (d) Tighten the stem bolt Hand Brakes Assembly and Adjustment WARNING: The hand brakes on this scooter were not adjusted at the factory. Before you ride the scooter you must assemble and adjust the hand brakes. Install bra ...

a) Loosen the anchor bolt nut. b) Squeeze the brake pads against the wheel rim again. c) Pull the brake cable wire through the anchor bolt hole until there is no slack in the inner brake wire. d) Tighten the anchor bolt nut. e) Squeeze the brake lever hard and then release it several times. Rotate the wheel; make sure it does not wobble. There should be about 1.6 mm clearance between the wheel rim and each brake pad. a. Brake cabl ...

replace them immediately.  Product modifications: The original product cannot be modified in any way that is not described in these maintenance instructions. Nuts, axles and other quick release mechanisms: We recommend to check these parts regularly. They can get loose over time. If that’s the case, they need to be tightened again. If the parts lose their effect ...

The Buyer is obliged to check the Goods delivered by the Seller immediately after taking the responsibility for the Goods and its damages, i.e. immediately after its delivery. The Buyer must check the Goods so that he discovers all the defects that can be discovered by such check. When making a Warranty Claim the Buyer is obliged, on request of the Seller, to prove the purchase and validity of the claim by the Invoice or Bill of ...