WilTec 51484 Operation Manual

51484 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us. ...

Item 51484 Page 2 http://www.WilTec.de http://www.aoyue.eu 09 2021-1 http://www.teichtip.de The information contained in this document may alter at any time without previous notice. It is prohibited to copy or spread any parts of this document in any way without prior written allowance. All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown. Even though, the WilTec Wildanger Technik GmbH has undergone biggest possible efforts to ensure that the operating manual is complete, faultless and up to date, ...

Item 51484 Page 3 http://www.WilTec.de http://www.aoyue.eu 09 2021-1 http://www.teichtip.de Introduction Thank you for purchasing this quality product. To minimize the risk of injury we urge that our clients take some basic safety precautions when using this device. Please read the operation instruc- tions carefully and make sure you have understood its content. Keep these operation instructions safe. Technical data Size (㎜) 780–1370×730×705 Width of holder (㎝) 81–122 Size of wheels (Zoll) 12–18 Max. number of wheels 4 Capacity (㎏) 130 Assembly instructions 1. First install the two main parts of this fo ...

Item 51484 Page 4 http://www.WilTec.de http://www.aoyue.eu 09 2021-1 http://www.teichtip.de 2. Mounting the upright supports to the wall studs: Install 2 wall studs that are 32″ to 48″ apart (measured from their centre). Make sure the holes are on the same level of height. Pre-drill the 2 marked holes using a 3⁄16″ drill bit (M: 32″ to 48″ centres). IMPORTANT NOTES: a) The unit MUST be installed on wall studs. Do not use wall anchors for mounting directly to sheet rock. b) Do not overtighten the lag screws (max. 13,6 Nm/10 ft.lbs.). They only need to be fully seated. 3. Mount parts (1) and (2) with expan- ...

Item 51484 Page 5 http://www.WilTec.de http://www.aoyue.eu 09 2021-1 http://www.teichtip.de 5. Tighten, adjust, and fold: All fasteners must be fully tightened. Store the unit in a folded position as shown. Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction manual require the written permission of WilTec Wildanger Technik GmbH. ...