Schrack HHDC2002 Quick Start Manual

070712_HHDC2002_QSG_EN.doc Page 1 Schrack Required tools: Screw driver, Cutter, Flush cutter. Make a small (+/- 3 cm) incision at the end of the cable and peel open the cable jacket. Locate the rip-cord and tear the cable open over a length of +/- 10 cm. Cut the rip-cord and make a small ...

070712_HHDC2002_QSG_EN.doc Page 2 Schrack Cut the wires flush to the wire organizer. Position the body of the connector and press the body onto the wire organizer. Tighten the screw until the connector is completely closed and the screw blocks. Secure the cable onto the connector by mean ...