PARKIT360 FORCE 5K Manual 

CAUSE DAMAGE TO YOUR TRAILER, PERSONAL INJURY OR EVEN DEATH. DANGER 5K & 10K MANUAL VERSION 4.1 ...

Ball Mount: 18”, 20” or 24” Tightening Bar Two Hitch Balls: 2” & 2 5/16” Thrust Washer (Puzzle) Hardware Kit: • 2 Handle Spring Clips • Allen Key • Battery Cable • Charger Cable (B2 + B3) IN THE BOX ASSEMBLY Insert the Handle into the Dolly and tighten both Allen Screws to secure it. Plug the Handl ...

1 7/8” or 50mm Hitch Ball Pintle Hitch Adapter Atwood Hitch Adapter Smart Brake U1 Battery Kit Battery Box Kit FEATURES SMART BRAKE (B2+B3) 7-Way Power Plug that Controls the Trailer’s Electric or Surge Brakes. BATTERY CABLE PLUG Power the Dolly with an On-board Battery or Connect to a Trailer Battery INTELLIGENT S ...

locking cap over connection. Unplug while charging. CIRCUIT BREAKERS By default, the Brake Button protrudes more than the Motor. VOLT METER Digital Meter that measures and displays Power Level of Battery. Fully Charged Batteries Rest between 12.6 to 13V. CIRCUIT BREAKERS Prevents Motors and Smart Brake from overh ...

POWER WHILE IT IS NOT UNDER LOAD. If you are in Engaged Mode, the wheels will be locked in the drive position. Without power, the Dolly will only move an inch forwards or backwards before stopping. Rock the Dolly so the wheels rest in between these two stop points. Pull on the Knob and turn it clockwise. Rest the sma ...

Connect the 80” Cable across Both Batteries: POWER OPTIONS PLUG CABLE INTO DOLLY TO turn ON or OFF U1 BATTERY KIT Plug the Pre-Installed Battery Cable into the Dolly to turn the Dolly ON or OFF. BATTERY BOX KIT Install the Battery Box with the Strap Provided. Use the 20” or 80” Cable to connect to a 12V Group 24 Deep Cycle Battery. TWO ...

MAX. WEIGHT CAPACITY CAN CAUSE DAMAGE TO YOUR TRAILER, SERIOUS INJURY, OR EVEN DEATH. RE-TIGHTEN BALL MOUNT BEFORE OPERATION USE JACK POST CONNECTION OR TELESCOPIC FRAME ADAPTER FOR TRAILERS: - BETWEEN 8,000-10,000 LBS GROSS WEIGHT - WITH MORE THAN 800 LBS TONGUE WEIGHT - WITH ARTICULATED HITCHES DO NOT OPERATE ON MORE THAN 6% ...

BALL MOUNT ADAPTER While in Freewheel Mode, move the Dolly and Accessories to the Trailer. Choose your preferred Hitch Ball Size, and assemble the Ball Mount. HITCH BALL Thread desired Hitch Ball into the Ball Mount. Apply a generous portion of All-Purpose Grease along the top surface of the Ball Mount Collar. The shoulder of the ...

into the Hitch and lock as normal. Make sure the Weld Spots on the Hitch Ball are pointed towards the rear left side of your trailer at about 10 o’clock. The hitch may not lock if they are not positioned properly! HITCH BALL PLACEMENT HITCH CONNECTION Turn the Ball Mount Counter Clockwise until the gap between the ...

the Ball Mount with the open section facing the trailer. While tightening, hold the Thrust Washer in place to prevent it from spinning. Need to increase Ball Mount Height? Interlock the Puzzle Piece. CONNECTION GAP? TIGHTENING BAR Once the Ball Mount is secure, use the Tightening Bar to ensure the connection is ...