Vello BG-S3-2 Quick Start Manual

time and comfort when shooting in a vertical (portrait) orientation. The grip is compatible with the Sony Alpha a7 II series mirrorless cameras and accepts up to two Sony NP-FW50 rechargeable batteries. It offers an alternate shutter release button, AF/MF/AEL button, three custom buttons, a ...

devices specified in this manual. 2. Use only with the batteries and battery holders recommended in this manual. 3. If you notice smoke, noise, or an unusual smell from the battery pack, discontinue use immediately. Remove the batteries, and take the device to a Vello authorized reseller. 4. ...

2 Front dial 3 Nonslip grip 4 Tripod socket 5 Battery compartment door 6 Battery compartment lock 7 Thumbwheel lock 8 Battery tray lock 9 Battery compartment 10 Mounting screw 11 AF/MF / AEL button 12 C3 custom button/enlarge viewing 13 Control lock switch 14 Hand strap mount 15 Rear dial 16 Shutter release button ...

1. Ensure that the camera power is turned off. Open the camera’s battery door, and remove the battery. 2. Remove the camera’s battery door by pulling the release latch on the inside of the door as indicated above. 3. Store the camera’s battery door in the BG-S3-2’s battery door compartment. Align the door with the compar ...

shut. 5. Inser t the BG -S3-2’s electrical contacts into the camera’s battery chamber, and seat the camera onto the grip’s mounting screw. 6. Rotate the thumbwheel lock until secure. 7 OVERVIEW ASSEMBLY INTRODUCTION ...

1. Turn the camera power off. Rotate the grip’s battery compartment lock to Open, and open the door. 2. Press the battery tray latch to the left to release the battery tray. Pull the tray out of the battery compartment. 3. Align your bat ter y’s contacts with either battery tray slot 1 or 2, and insert the battery. Make sure th ...

into the grip’s battery compartment, close the door, and rotate the battery compartment lock to Close. 5. Turn on the camera’s power, and make sure the grip’s control lock switch is set to On. Note: When removing the grip, turn off the camera power and remove the batteries. 9 OVERVIEW ASSEMBLY INTRODUCTION ...

Operating temperature 32°F to 104°F (0°C to 40°C) Dimensions (H × W × D) 4 × 5 × 2.5 in. (10.2 × 12.7 × 6.4 cm) Weight 6.1 oz. (173 g) without batteries Specifications When two batteries are installed in the BG-S3-2, your camera will automatically select the battery with less power remain ...