Panasonic VL-FKD2BX Getting Started

Table of Contents Introduction 2 Accessory information 3 For your safety 4 Important safety instructions 5 For best performance 5 Other important information 5 Controls 7 Installation/Registering the repeater to the main monitor 8 Wall mounting 9 Troubleshooting 10 Cleaning 10 Specifications 10 General information 11 Thank you for purchasing a Panasonic product. Please read this manual before using the product and save it for future reference. 1-62, 4-chome, Minoshima, Hakata-ku, Fukuoka 812-8531, Japan http://www.panasonic.net/ © Panasonic System Networks Co., Ltd. 2013 PNQX6476ZA PC1213MT0 ...

Systems. – VL-SWD501BX/VL-SWD501UBX (Main monitor station: VL-MWD501BX) (The corresponding models are subject to change without notice.) R By installing this product, you can extend the range of your Video Intercom System to include areas where reception was previously not available. The product extends the range in all directions, allowing several floors to be covered. R You must register this product with your Video Intercom System before it can be used. R Keep an appropriate distance from the main monitor to maximise the range of your ...

n Using each repeater connected separately This extends signals away from the main monitor. Because signals are sent through the main monitor, different types of devices can be connected to each repeater. (For example, sub monitors can be connected to one repeater and cameras can be connected to another.) This is useful when you want to connect to different types of devices over shorter distances. n Using 2 repeaters connected together This extends the signal away from the main monitor by sending signals directly between repeaters. Because the signals are sent between repeaters, the same type of device mus ...

To prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product. WARNING Preventing fire and electric shock R Use only the power source marked on the product. If you are not sure of the type of power supplied to your home, consult your dealer or local power company. R Use only the specified AC adaptor. R Do not attempt to disassemble or modify this product. Contact an authorised service centre for repairs. R Never touch the AC adaptor with wet hands. R Do not touch the AC adaptor during an electrical storm. R Do not perform any actions (such as ...

When using your product, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Do not use this product near water for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement or near a swimming pool. 2. Use only the AC adaptor indicated in this manual. SAVE THESE INSTRUCTIONS For best performance Location/avoiding noise The repeater and other compatible Panasonic units use radio waves to communicate with each other. (The product operates in the frequency range of 1.88 GHz to 1.90 GHz, and the RF transmissio ...

Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. Others R It is prohibited to disassemble or modify this product. Contact the dealer where you purchased this product for repair. R When power fails, this product cannot be used. 6 ...

repeater can send signals. Flashing green Signals are being sent. Lit orange Signals are not being sent. ID indicator Flashing green Currently registering to the main monitor. Off Not registered to the main monitor. Lit green Strong Indicates the signal level of the main monitor. R Determine the installation location of the repeater by checking the signal level shown with the indicator. Lit orange Lit red Weak Flashing red Signals do not reach the rep ...

1 Repeater: Connect the AC adaptor, and plug the AC adaptor into a power outlet. R Use only the supplied Panasonic AC adaptor (® page 3). R When the repeater is turned on, the indicator lights in orange. A B C *1 A PROGRAM B Hook C 220-240 V AC, 50/60 Hz *1 Press plug firmly. 2 Main monitor: Perform the registration operations for the repeater. (® Operating Instructions of the Video Intercom System) R The next step must be completed within 120 seconds. 3 Repeater: Press PROGRAM (A) for about 3 seconds. R If the indicators do not light green, re-position the repeater in a place where the indic ...

1 Place the reference for wall mounting on the wall to mark the 2 screw positions. 2 Install the 2 screws (locally procured) into the wall. R Make sure that the screw heads are at the same distance from the wall. R Install the screws perpendicular to the wall. 3 Hook the repeater on the screw heads. Reference for wall mounting Print the following guide and use it as a reference for wall mounting. R Make sure to set the print size to correspond with the size of pages in this manual. If the dimensions of the printed paper are not exactly the same as the dimensio ...

R When the indicators do not light, the AC adaptor is not connected properly. Check the connections. R When the indicators do not light green, move the repeater closer to the main monitor. R When the ID indicator does not light, the registration with main monitor has not completed successfully. Re-register the repeater again. The transmission condition (for images and sound) of the sub monitor or camera does not improve even when a repeater is installed. R The sub monitor or camera is too far from the repeater. →Install the sub monitor or camera within signal range of the repeater. R ...

Operating environment Ambient temperature: approx. 0 °C to +40 °C Relative humidity (non-condensing): up to 90 % Frequency range 1.88 GHz to 1.90 GHz Transmitting range Approx. 100 m (line-of-sight distance from the main monitor) Note: R Design and specifications are subject to change without notice. R Names, company names, product names, software names, and logos mentioned in this manual are trademarks or registered trademarks of the companies concerned. General information R In the event of problems, you should contact your equipment supplier in the first instance. For your future reference We r ...