THK Ball Spline Instruction Manual

www.thk.ru тел. +7(499) 703-39-86 [email protected] ...

i Ball Spline 1. Introduction 1-1 1-1 Foreword―――――――――――――――――――――――――――――――― 1-1 1-2 About This Manual―――――――――――――――――――――――――――― 1-1 1-3 Applying This Product― ――――――――――――――――― ...

assembly method, and lubrication method that apply to a Ball Spline. 1-2 About This Manual 1-2-1 Intended Audience Persons in charge of product mounting design, installation, wiring, and maintenance, and perso ...

z z Do not use this product for equipment or systems used in life-threatening situations. z z Consult THK beforehand when considering using this product for special applications such as in passenger vehicles or in medical, aviation and space, nuclear power, or electrical power equipment or systems. z ...

2-1 Safety Related Warning Displays This manual uses the following safety related warning displays. Descriptions containing safety related warning displays are serious and must be followed. The Ball Spline is a precision part, to be handled with care based on the following information. Warning "A matter ...

Ball Spline 2-3 Precautions on Use C A U T I O N Prevent dust z z Prevent foreign materials, such as cutting chips or coolant, from entering the product. Failure to do so could damage the product. z z Prevent foreign materials, such as cutting chips, coolant, corrosive solvents or water from getting in the product by ...

Ball Spline 2-4 Lubrication C A U T I O N Check lubricant z z Thoroughly remove anti-rust oil and feed lubricant before using the product. z z Do not mix different lubricants. Even grease containing the same type of thickening agent may, if mixed, interact in an adverse manner due to disparate additives or other ingr ...

Figure 3-1 and Figure 3-2 show examples of mounting the spline nut. Although the Ball Spline does not require a large amount of strength for securing it in the spline shaft direction, do not rely only on a press fit to support the nut. Note: Both ends of the Ball Spline SLS model with a retaine ...

www.thk.ru тел. +7(499) 703-39-86 [email protected] ...

When installing the spline nut into the housing, do not hit the side plate or the seal; gently insert it using a jig (Figure 3-3). di D-0.5 Figure 3-3 Installing the Spline Nut Table 3-1 Model LBS Jig Dimensions  Unit: mm Nominal shaft diameter 15 20 25 30 40 50 60 70 85 100 120 150 di 1 ...