Vantec NBA-100U Operation & User’s Manual
Text of the manual
USB External 5.1 Channel Audio Adapter
Table of Contents
Introduction…………………………………………..…………………………1
Package Contents…..………………………………………..…………..……1
Safety Instructions…..……………………………………………………...…1
Sp
The Vantec NBA-100U USB external 5.1 Channel Audio Adapter is an
amazing audio accessory for any computer with a USB port. Its 5 audio
connections provide both great stereo input and 5.1 channel surround
sound output performance from your laptop or desktop without installing
additional hardware. The NBA-100U not only combines high quality audio
● Compliant with USB specification V1.1
● Compliant with USB audio device class specification V1.0
● Compliant with USB HID class specification V1.1
● Plug-and-play operation with Microsoft OS/ Mac OS default drivers
● Full-duplex playback/recording audio stream without sound card in PC
● LED indicator for Power (always red)/Playbac
Plug the USB Audio Adapter Type A Connector into the available USB
port of your PC or MAC.
2.
The system will detect this drive and install the driver automatically.
3.
Open the “Device Manager” to check the following devices (Fig.1 &
Fig. 2):
z The “HID-compliant consumer control device”
z The “USB Human Interface Device�
Application Software Installation (for Windows only)
This software can help your system to expand 2-channel stereo to high
quality 5.1 Channel Audio effect. Please follow the instructions below:
1.
Turn on the power to your system unit and insert the Application
Software CD to the CD-ROM drive.
2.
The InstallShield Wizard will guide you the steps till the in
Check the Destination Folder and click “Next” to continue.
5.
Click “Finish” to complete the Sound Station Setup.
6.
Click “OK” to launch the Sound Station.
5
To verify the installation, click the icon “S” of the Toolbar on the
desktop, and then click “Open Setting”.
8.
The “Control Panel” opens up.
6
How to Use Your Audio I/O Devices
Rear Audio
Center/Sub
Woofer
Front Audio
Mic-in
Line-in
1. 5.1 Channel Speaker:
Plug speaker cable into the speaker/line-out jack (jack A, B, and C) on
the USB 5.1 Channel Audio Adapter.
2. Mic-In:
Plug in a MONO microphone into the Mic-in jack (jack D) on the USB
Audio Adapter.
3. Stereo Audio Input:
Plug in a STEREO line i
You can often resolve a few basic problems by checking:
z The power of the speaker
z The sound volume
z The cable connections
z The audio CD compatibility
No Sound Is Recorded
You can often resolve a few basic problems by checking:
z If the MIC is probably connected
z If the file is saved and opened properly
Certificate
FCC
This equi
Information in this document is subject to change without notice. The
manufacturer does not make any representations or warranties (implied or
otherwise) regarding the accuracy and completeness of this document and
shall in no event be liable for any loss of profit or any commercial damage,
including but not limited to special, incidental, consequ