Telic NT910G Operation & User’s Manual

Text of the manual

1 General Terms and Conditions ............................................................................... 3

1.1 General Information ................................................................................................................................................. 3 1.2 Contact for Support ..........................................

User Manual - Telic AG

Pg 2 5.8 Additional Software Configuration .................................................................................................................. 23 5.8.1 Activating / Deactivating LTE Mode ................................................................................................................ 23 5.8.3 Conf

User Manual - Telic AG

Pg 3 1 General Terms and Conditions This technical description contains important information for the installation and use of the NT910G Terminal. Read it carefully before you start working with the NT910G Terminal. We cannot be held responsible for material loss or personal injury that is due to non-compliance with the safety

User Manual - Telic AG

Pg 4 1.3 Conventions used in this Manual The following conventions for warning levels are used in this manual: Warning Warnings against hazards that may result directly in serious injuries or death in case of non-observance. Caution Warnings against hazards that may result in injuries in case of non-observance. NOTICE Warnings

User Manual - Telic AG

Pg 5 GPRS General Packet Radio Service GSM Global System for Mobile Communication ME Mobile Equipment MO Mobile Originated MS Mobile Station PDU Protocol Data Unit RF Radio Frequency SIM Subscriber Identity Module SMS Short Message Service TA Terminal Adapter TE Terminal Equipment TS Telecom Services Table 1: Abbreviation 1.6

User Manual - Telic AG

Pg 6 Figure 1: Connector on rear side of the Terminal Figure 2: Connectors on front side of the Terminal PLEASE NOTE THE FOLLOWING: ▪ The terminal can be securely fitted into your application by using the mounting holes positioned at the two corners of the device. ▪ The SIM card can be inserted into the modem without the n

User Manual - Telic AG

Pg 7 Special DIN Rail Mounting Brackets (Art-nr. 12304 or Art-nr. 12305) is available as an accessory item which allows installation of the modem in industrial environments using DIN Rails. For more details of our accessories please check chapter 2.5 Telic Certified Accessories. 2.2 Identification On the bottom of the device,

User Manual - Telic AG

Pg 8 Figure 3: Drawing of the Terminal’s Housing 2.4 Product Features and Technical Data NOTICE Telic AG may, at any time and without notice, make changes or improvements to the products and services offered and / or cease producing or commercializing them. NOTICE – Optional Features Features identified as “Optional” i

User Manual - Telic AG

Pg 9 B19(800) / B20(800) / B26(850) / B28(700) Hardware Features IP Protection IP40 SIM Card Holder 1x (1,8/3 Volt) Size: 25 x 15 mm Mini-SIM, Form Factor: 2FF SIM Chip Option: Yes LEDs 1x Mobile communications 2x Configurable Type Approvals CE Connectors D-Sub (9-pin) 1x Female (RS232) USB 1x Mini-USB (USB 2.0) RJ11 1x Power

Other Touch terminals Manuals