Ubiquiti EdgeRouter PoE ERPoe-5 Quick Start Manual

EdgeRouter™ PoE 5-Port Router. This Quick Start Guide is designed to guide you through installation and also includes warranty terms. Package Contents EdgeRouter ERPoe-5 Power Adapter (48V, 1.25A) Power Cord Screws (Qty. 2) Screw Anchors (Qty. 2) TERMS OF USE: All Ethernet cabling runs must use ...

Console Reset Ethernet (eth0-eth4) Interface Description Console RJ45 serial console port for Command Line Interface (CLI) management. Use a RJ45‑to‑DB9 serial console cable to connect the Console port to your computer. Ethernet (eth0-eth4) All ports can be used for routing and support 10/100/1000 Mbps connections with ...

Power Speed/Link/Act PoE LED State Status Console Power Off Power off Green Power on Ethernet (eth0-eth4) PoE Off No Power over Ethernet Green 24V Power over Ethernet Amber 48V Power over Ethernet Speed/ Link/ Act Off No Link Amber Link Established at 10/100 Mbps Amber Flashing Link Activity at 10/100 Mbps Green Link Established at 1000 Mbps ...

• Phillips screwdriver • For indoor applications, use Category 5 (or above) UTP cabling approved for indoor use. • For outdoor applications, shielded Category 5 (or above) cabling should be used for all wired Et ...

1. Use a 6 mm drill bit to drill two holes 100 mm apart. 2. Insert the Screw Anchors into the holes. Use a Phillips screwdriver to secure a Screw to each anchor. Leave a clearance of approximately 3 mm between each screw head and its anchor. 100 mm 3 mm Note: The EdgeRouter PoE may also be mounted in a v ...

The EdgeRouter PoE is grounded through the Power Adapter; however, you can add optional ESD grounding for enhanced ESD protection. 1. Loosen the grounding screw and secure a ground wire (not included) to the Grounding Point. 2. Secure the other end of the ground wire to a grounding block or other grounded structur ...

2. Connect the Power Cord to the Power Adapter. Connect the other end of the Power Cord to a power outlet. ...

The EdgeOS® configuration interface can be accessed via DHCP or static IP address assignment. By default, eth1 is set up as a DHCP client, while eth0 is assigned a static IP address of 192.168.1.1. To configure the EdgeRouter, proceed to the appropriate section: DHCP or “Static IP Address”. DHCP 1. Connect a ...

and Password fields. Read the Ubiquiti License Agreement, and check the box next to I agree to the terms of this License Agreement to accept it. Click Login. The EdgeOS Configuration Interface will appear, allowing you to customize your settings as needed. For more information, refer to the EdgeOS ...