Techni Sport TS83 Assembly Instructions Manual

GAMING CHAIRS MODELS: ASSEMBLY INSTRUCTIONS TS83, TS84, TS90, TS92, TSF44 AND TSXXL2

E x1 F x5 G-L x1 G-R x2 Hydraulic gas lift Casters Left armrest Right armrest H X1 Set I-L x1 Covers for gas lift Left cover for seat bracket I-R x1 Right cover for seat bracket LIST OF HARDWARE PART QTY ITEM USE IN K 1 Allen Wrench Steps 2, 3, 5 and 6 L 4 M8x20 Mechanism to seat M 12 M8x25 Arms to seat, Seat to backrest N 2 M5x12 Covers to brackets O 16 O-Rings Mechanism, armrests and seat brackets P 16 Washers Mechanism, armrests and seat brackets Q 4 Felt gaskets Mechanism to seat R 4 Hole covers Armrests P.1 Models: TS83, TS84, TS90, TS92, TSF44, TSXXL2 P.1 Sitting on the chair, not looking at it J-L x1 Lumbar pillow J-N x1 Neck pillow Except TS84

AND WARNINGS. ❶Do a quick inventory to make sure the package contains all the parts and hardware listed in the assembly instructions. ❷Missing, damaged and defective parts can be replaced at no cost to you. Please refer to the last page in this manual. ❸The replacement parts service is limited to the continental United States. If you reside in Hawaii, Puerto Rico, U.S. Dependencies or other countries, please contact the supplier from where the unit was purchased. ❹If during assembly you find an issue or need clarification, please contact our Customer Service for assistance. Please refer to the last page in this manual. ❺On each step read the instructions and analyze the illustrations thoroughly before proceeding to do the assembly. ❽Do not overtighten or force the screws as they might break, strip, damage the threads of the holes or get stuck inside the part. ❻Make sure you understand which hardware will be used on each step. Using the wrong size of screw, bolt or pin might strip the threads or cause damage to the part in which it is being used. ❼To avoid misalignments, always leave the screws loose and tighten them until all pieces are positioned correctly. ❾If the hole seems too big or too small for the screw, first make sure you are using the correct size of screw and that it’s been installed in the correct hole. Test another of the same screw into the same hole, as well as test the screw onto different holes for the same part. If the hole still appears to be too small, do not force it, it needs replacing. P.2 Models: TS83, TS84, TS90, TS92, TSF44, TSXXL2 P.2

towards your LEFT, and place the felt washers Q over the innermost holes then place the mechanism D, and secure it with screws L, O-rings O and washers P, making sure the screw knob faces towards the FRONT as shown. P.3 Models: TS83, TS84, TS90, TS92, TSF44, TSXXL2 P.3 (Front) STEP 2 Hardware K L M8x20 4 Pcs O 4 Pcs P Washer 4 Pcs Q Felt gasket 4 Pcs Insert the casters F into the legs of the base C using pressure, then place the gas lift E in the middle of the base and cover it with H. STEP 1 L P O Q B D C F E H Assemble the armrests G to the seat B in their respective sides with screws M, O-rings O and washers P as shown. LEFT G-L RIGHT G-R IMPORTANT: The O-ring O must go above the washer. O P STEP 3 Hardware K M M8x25 8 Pcs O 8 Pcs P 8 Pcs M P O (Front) (4 sets of hardware per armrest) B

A to the brackets on the seat B with screws M, O-rings O and washers P as shown. Attach the covers I to the seat brackets on their respective sides with screws N then cover the screw holes with R. P.4 Models: TS83, TS84, TS90, TS92, TSF44, TSXXL2 P.4 ALL DONE! Give yourself a nice pat on the back. You did a great job! Put the seat over the base parts making sure the tip of the gas lift E enters into the hole of the mechanism D. (Front) STEP 4 D E STEP 5 Hardware K M M8x25 4 Pcs O 4 Pcs P 4 Pcs B IMPORTANT: The O-ring O must go after the washer. O P A M O P STEP 6 Hardware K N M5x12 2 Pcs R 4 Pcs R N I-R R N I-L STEP 7 Attach the pillows J-L and J-N to the backrest A by fastening the buckles from behind. Except TS84 J-N J-L (2 sets of hardware on each side) A

you lift your body. ②Seat tilting: Pull the same lever OUT horizontally to unlock this function, and IN to lock again. NOTE: Unlike regular office chairs, these racing/gaming chairs have their base components off-center, and the tilting won’t be much and might actually feel hard to tilt. ③Tilt tension: Turn the mechanism’s knob in either direction to apply more or less tension. With less tension, the tilting will feel easier. Please read the above note about the tilting. ④Backrest reclining: pull UP the lever located on the rear right side of the seat and release it when the desired position is reached. WARNING: For your safety, the seat’s tilt function ②should be in the LOCKED (IN) position prior to use the backrest reclining function. ⑤Armrest height: Pull UP the button that is under the armrest. Some models have additional functions like forward/back, in-out and pivot. CHAIR’S FUNCTIONS P.5 Models: TS83, TS84, TS90, TS92, TSF44, TSXXL2 P.5 2 1 CHAIR’S FUNCTIONS WARNINGS • Do not exceed the indicated weight limit. • Do not stand up on the chair or use it as ladder. • Use the chair to seat only one person at a time. • Do not use the chair if parts are damaged or if screws are loose or missing. • Do not sit near the edge of the seat and always sit properly on the chair to avoid going beyond your balance point and fall off the chair. • The chair is intended for teenagers and adults. If small children are using the chair, please keep close observation on them. • Do not allow small children to play with the chair. • Not paying attention to these warnings could result in severe injuries. • To clean the chair it is recommended to use a soft cloth lightly damped in a solution of smooth soap and water, then dry with a clean towel. • Do not use solvents or abrasive materials to clean any part of the chair. • Before applying a cleaning agent, test on a small hidden area of the chair, like underneath the seat. • Do not expose the product to direct sunlight or to extreme environmental conditions. • Every 4 months, inspect the chair completely and make sure that all screws are tighten. CARE AND MAINTENANCE ❹ ❺ 3 Weight Limit Model 250 Lbs TS90 TS92 TSF44 300 Lbs TS83 TS84 400 Lbs TSXXL2

Gaming Chair: 2-YEAR WARRANTY Gaming Desk: 5-YEAR WARRANTY Gaming Chair Metal Frame: LIFETIME WARRANTY RTA Products, LLC has warranted the Techni Sport products to the original purchaser who acquired a new product from RTA Products or its authorized re-sellers of the product against defects in material or workmanship. This warranty is expressly limited to the repair or replacement (at its option) of defective product components or materials as a result of a defect in materials or workmanship. This warranty is limited to merchandise purchased in the Continental United States. No assembly labor is included. The word "defects" as used in this warranty, is defined as imperfections that impair the utility of the product. This warranty applies under conditions of normal use, but does not apply to defects that result from intentional damage, wear & tear, negligence, unreasonable use or exposure. Liability for consequential damages is excluded to the extent exclusion is permitted by law. This warranty gives you specific legal rights, and you may have other rights that vary from State to State. RTA Products does not warrant: a) natural variations in character marks b) changes in surface finishes due to aging or exposure to light c) marks, scars, or wrinkles occurring naturally in leather d) failure resulting from normal wear and tear e) the matching of colors, grains, or textures of natural materials f) the colorfastness or the matching of textiles, including an exact match to cuttings or to swatch cards g) damage, marking, or staining of veneer surfaces due to contact with rubber or similar compounds, damage from sharp objects or imprinting from writing instruments, or prolonged exposure to direct sunlight h) we do not warrant products that are exposed to extreme environmental conditions or that have been subject to improper storage. RTA Products shall not be liable for loss of time, inconvenience, commercial loss, or incidental or consequential damages. Any modification to the original product voids the warranty. We do not warrant the performance of the product when used in combination with other than original products. This product has been designed for and is intended for office, home-office and gaming use only. This warranty is Original Purchaser’s sole remedy for product defects, and this warranty does not extend to any product, or damage to any product, caused by or attributed to abuse or misuse, products used for commercial or rental purposes, use modifications of, or attachments to the product, and products or parts not used, maintained, or extended here under is in lieu of any and all other warranties, express or implied, including without limitations any implied warranty or merchant ability or of fitness for a particular purpose. Report any defects to RTA Products, LLC together with your sales receipt or other proof of purchase. If the chair is defective within the terms of the warranty, RTA Products, LLC will furnish a replacement chair (at its option) at no cost of equal or similar value and design. RTA Products will advise you of the procedure to follow in making warranty claims. The following are the procedures for warranty claims: a) Call us Monday – Friday, from 9am-5pm (Eastern Time) at (866) 782-5520 to explain the defect and give your name, address and phone number. Please have ready the model number of our product, date and place of purchase. You can also write to us by e-mail to [email protected] and include the same information. b) If we determine that replacement will remedy the situation, and in order to determine the extent or the cause of the defect, purchaser will need to send the part in question at purchaser’s expense. Once we receive the part, we will examine it and determine whether the claim is valid (or not), and then proceed to send the replacement. We will ship the replacement at our expense. P.6 Models: TS83, TS84, TS90, TS92, TSF44, TSXXL2 P.6

CLICK ON SUPPORT TAB Scan QR Code to order replacement parts CONTACT US BY EMAIL: [email protected] P.7 Models: TS83, TS84, TS90, TS92, TSF44, TSXXL2 P.7 • Assembly questions • Damage issues • Replacement parts _________________________________________________________________ _________________________________________________________________