Murata Type1LD Application Note

Text of Murata Type1LD Application Note

Type1LD Application note HW

Page 1 Introduction This Application Note targets HW developers. It provides how to design the Schematic and Layout, and reference RF performance For Type1LD-EVK manual and quick start guide of WICED refer to “N1-4629_Type1LD-Quick_Start_Guide_*” For Module specification refer to “SP-PA1LD-*” Document Number: E2B-74-0875 V

Type1LD Application note HW

Page 2 Revision History Revision Number Release Date Comments 2017.Nov.2nd 1st issue A 2018.Dec.28th 2.1 reference circuit : reviced B 2019.Aug.20th 2.1 2) 32.768kHz from STM32F412 to CYW43438:Added comment 2.1 4)External Flash : reviced

Type1LD Application note HW

Page 3 TABLE OF CONTENTS 1 Module introduction ................................................................................................................ 4 1.1 Type1LD Introduction ......................................................................................................... 4 1.2 Block Diagram ...................

Type1LD Application note HW

Page 4 1 Module introduction 1.1 Type1LD Introduction  WLAN(11b/g/n)+BT/BLE(BT4.1)+MCU(Cortex M4) combo SIP module with Cypress CYW43438+ST micro STM32F412  Supprted WICED_studio of Cypress  The package type is LGA(SM type)  This module is covered with resin molding and fully shielded with metal  MAC and BD address

Type1LD Application note HW

Page 5 2 Reference Circuit 2.1 Reference Circuit Figure-2 shows the reference circuit of Type1LD module. 1) 32.768kHz to STM32F412 Table-1 shows 32.768kHz oscillator characteristics for Type1LD. Symbol Parameter Conditions Min Typ Max Unit RF Feedback resistor - - 18.4 - MΩ IDD LSE current consumption Low-power mode (default) - -

Type1LD Application note HW

Page 6 tested in production. It is measured for a standard crystal resonator and it can vary significantly with the crystal manufacturer. *3. +/-200ppm is required for CYW43438. 2) 32.768kHz from STM32F412 to CYW43438 The external 32.768kHz clock is required. Murata platform folder "MurataType1LD" configures Pin #17 (PA8/MCO_1) as

Murata Control Unit Owners Instructions: