REDATOM REDMC70 Instruction Manual
Text of REDATOM REDMC70 Instruction Manual
Max Screen Size: 60”
CAUTION: THE MAXIMUM LOADING WEIGHT
IS 70 LBS. USE WITH PRODUCTS HEAVIER THAN
THE MAXIMUM WEIGHT INDICATED MAY RESULT IN
INSTABILITY AND POSSIBLE PERSONAL INJURY.
!
REDMC70
INSTRUCTION MANUAL
MANUAL DE INSTRUCCIONES
MANUEL D’INSTRUCTIONS
V2
Medium Full Motion Mount
DISCLAIMER – WARNING INFORMATION
Disclaimer –. RED ATOM has extended every effort to ensure to accuracy and completeness of this manual. However, RED ATOM does not claim that the
information covers all installation and or operational variables. The information contained in this document is subject to change without notice
MONITOR PLATE AND ADAPTERS
Use diagrams to determine which mounting configuration is needed to attach Monitor
Plate (with or without adapters) to the back of flat panel. Please check flat panel wall
mounting compatibility before proceeding with installation.
Pay attention to below for the correct installation pattern of adapters A and B.
!
400 mm (15.7 in.)
400 mm (15.7 in.)
300 mm (11.8 in.)
200 mm (7.9 in.)
200 mm
(7.9 in.)
100 mm
(3.9 in.)
300 mm (1
HARDWARE PART NUMBERS
B
A
D
PRODUCT COMPONENT PARTS
B
CB
CA
Product Components
Contents
Qty
Description
A
1
Wall Plate
D
2
Plastic End Caps
B
1
Monitor Plate
2
Monitor Adapters A
CA
2
Monitor Adapters B
CB
14
PHILLIPS
SCREWS
X 8
9
5mm
SPACER
X 4
12
8
SQUARE
WASHER
X 4
5
1
2
M6 x 15
X 4
M8 x 15
X 4
M6 x 30
X 4
M8 x 30
X 4
3
6
M4 x 12
X 4
4
M4 x 30
X 4
STEEL
WASHER
X 8
11
10mm
SPACER
X 4
10
LAG BOLT
8mm x 65mm
X2
13
WALL
ANCHOR
X 2
M8 x 45
X 4
7
STEP 2A- MONITOR PLATE ATTACHMENT
STEP 1- REMOVE MONITOR PLATE FROM MOUNT
Remove and save Phillips head
screws and washers. Screws and
washers will be used to reattach
monitor plate in step 5.
Conecte el adaptador al monitor
Connectez l'adaptateur au moniteur
8
Connect monitor plate to flat panel
1
2
3
STEP 2C- CURVED BACK FLAT PANEL (MONITOR PLATE)
STEP 2B- MONITOR ADAPTERS ATTACHMENT TO MONITOR PLATE
Connect monitor plate with adapters to flat panel (if necessary)
Conecte el adaptador al monitor
Connectez l'adaptateur au moniteur
14
9
or
10
Spacers to be used when
back of panel is curved or when
more clearance is required.
Spacers can be stacked 5mm +
5mm between panel and monitor
plate to allow for maximum of
10mm clearance.
B
Connect monitor plat