Morphy Richards ORB Pets Cyclone Manual 

Please read and keep these instructions Getting the best from your new cleaner... If your cleaner is not picking up as well as it should, please check VC73174 MUK Rev4 If you have a problem or complaint, please call our dedicated UK based helpline before returning your product to the retailer from where it was purchased. UK Helpline: 0844 871 0949 Replacement Parts: 0844 873 0715 Ireland Helpline: 1800 409 119 Filters It is important to clean the dust compartment filter every time you empty the dust container, otherwise the performance of the cleaner will be impaired. See page 5 - Cleaning the filter. A spare filter is provided. Blockages Check the hose, tubes and tools for blockages. Please note: Crevice tool / brush and upholstery nozzle are stored underneath the dust compartment lid - see page 3. Turbo nozzle The turbo nozzle is particulary useful for the removal of hairs from carpets and upholstery. Safety cut-out If the cleaner overheats, a motor protection device will automatically switch the motor off. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for 60 minutes. Check the airways for blockages, empty the dust container, clean the dust container filter and replace the exhaust filter if necessary before restarting the cleaner. 73174 rev4:73174 rev4 16/02/2009 15:53 Page 1

appliance requires the following of common sense safety rules. Primarily there is danger of personal injury and secondly danger of damage to the appliance and property. These are indicated in the instructions text by the following two conventions: WARNING: Danger of personal injury IMPORTANT: Damage to the appliance In addition, we offer the following essential safety advice. Location • Do not use or keep this product outside. • Do not store the appliance near hot surfaces e.g. ovens or heating appliances. Mains lead • Do not allow the mains lead to become strained or run this appliance over it. • If the electrical cable becomes damaged, the cable assembly must be replaced. Do not attempt this task yourself, contact the helpline number that is found at the bottom of the page. Your safety • The plug must be removed from the wall socket before cleaning or maintaining the appliance. • Never modify the cleaner in any way. • Never use in the presence of explosive liquids or vapours. • Never pick up inflammable or poisonous liquids such as petrol, copier toner or other volatile substances. Never pick up acids, asbestos or asbestos dust. • Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. • Use only genuine Morphy Richards spare parts and accessories. • The appliance must never be left running when unsupervised. • This vacuum cleaner is intended for domestic use only. Misuse or use for commercial or any other purpose will render the guarantee invalid. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Product safety • Never use the appliance without the bag or filters being installed. • Never use the appliance to vacuum hot ashes, broken glass, sharp objects or liquids. Children • Children do not understand the dangers associated with operating electrical appliances. Never allow children to use this appliance. • Children should be supervised to ensure that they do not play with the appliance or stumble over the power cord. ELECTRICAL REQUIREMENTS Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A.C. (Alternating Current). If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted. If you cut off the plug and let go of the cable it will rewind into the machine therefore you must pull out a length of cable and secure it before cutting the plug off and re-fitting a new one. WARNING: The plug removed from the mains lead, if severed, must be destroyed, as a plug with a bared flexible cord is hazardous if engaged into a live socket outlet. Should the fuse in the 13 amp plug require changing, a 13 amp BS1362 fuse must be fitted. UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119 73174 rev4:73174 rev4 16/02/2009 15:53 Page 2

¤ Cable rewind pedal ‹ Carrying handle › On/off power foot pedal fi Variable power dial flLid release buttons ‡ Washable dust compartment filter (see page 5) · Dust collection container ‚ Lid „ Parking slot ‰ Exhaust filter cover  Airflow regulator Accessories Ê Hose handle Á Flexible hose (Ê and Á assembled as one) Ë Telescopic tube (length adjustable) È Crevice tool with brush Í Upholstery nozzle Î Wheeled floor nozzle Ï Turbo nozzle Note : È and Í are stored beneath the lid. 3 ⁄ ¤ ‹ › fl Ê Á Â Ë Î ‰ fi ‡ ‚ „ · È Í Ï For details of other Morphy Richards products, please visit our website: 73174 rev4:73174 rev4 16/02/2009 15:53 Page 3

Ireland Helpline 1800 409 119 OPERATING THE APPLIANCE Quick start 1 Assemble the nozzle, telescopic tube and hose as shown on page 3. 2 Pull out the mains cable to it’s full length and plug into the mains supply. 3 Switch on by pressing the foot pedal ›. Accessories 1 Fit the hose to the cleaner by inserting the hose end into the hose inlet ⁄. When removing, squeeze the clip and pull. 2 Attach the telescopic tube to the handle end of the hose. Extend to the required length by pressing down the slider release and pulling out the tube A. The hose handle features an airflow regulator  which allows suction to be reduced as required. 3 Attach the wheeled floor nozzle Î to the tube. The crevice tool È is ideal for use in awkward places, behind radiators etc, and the upholstery tool Í for curtains and upholstery B. Both these tools are stored beneath the lid. CONTROLS Power The on/off control is operated by the foot pedal ›. Variable power A dial fivaries the suction power as required. For example, maximum suction can be used for cleaning carpets, hard floors etc. and reduced suction for cleaning upholstery and curtains. Suction can also be controlled using the airflow regulator  on the handle. Closed for maximum suction, open for reduced suction. Automatic cable rewind After use, unplug and press the cable rewind pedal ¤ to retract the cable. WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly. Using the turbo nozzle Attach the turbo nozzle Ï to either the hose handle to clean stairs or upholstery or the telescopic tube for floor cleaning. Do not pick-up large debris with the turbo nozzle as this may block the fan inside the turbo nozzle. Cleaning the turbo nozzle To maintain optimum performance, regulary remove any hairs or fibres that may have become wrapped around the brush. Snip the hairs/fibres with scissors before pulling away. If debris get into the fan, the flap on the bottom of the nozzle may be opened to remove. Make sure the flap is securely closed before re-use. È Í A B 73174 rev4:73174 rev4 16/02/2009 15:53 Page 4

your cleaner, empty the dust container regularly, otherwise the airflow and cleaning power will be reduced. 1 Open the lid by pressing the release buttons fleither side C. 2 Lift the container away from the product D. 3 Holding the dust container over a dustbin, lift up the flap on top of the handle and press the dust container release button as shown E. The bottom of the dust container will drop down to release the dirt. 4 Close the bottom of the dust container by pressing the base upwards until it clicks into place. 5 Re-insert the dust container into the product and close the lid to re-fit F. Cleaning the dust compartment filter It is essential that filters are cleaned regularly to maintain performance. 1 Remove the dust container from the product as detailed in the previous section. 2 Lift the filter ‡ out of the container G. 3 Remove the top foam filter as shown H. Gently shake the foam clean. The pleated filter can be gently knocked against the side of the dustbin to remove excess dust. To refit the filter, reassemble and locate into the hole in the top of the dust container. • The filter should be regularly washed in cold water and left to air dry before inserting back into the machine. IMPORTANT: Do not use detergents to clean the filter. The filter must be thoroughly dry before the machine is used. A spare filter is provided. IMPORTANT: The dust container will not lock back onto the machine unless the filter is fitted correctly. C D E F G H For details of other Morphy Richards products, please visit our website: 73174 rev4:73174 rev4 16/02/2009 15:53 Page 5

Ireland Helpline 1800 409 119 6 Pre-motor filter An additional pre-motor filter is located underneath the dust compartment lid. Lift up the lid, the filter is located to the rear I. This should only require occasional cleaning. Remove and shake rigorously to clean. Cleaning the exhaust filter The exhaust filter ‰ is located at the back of the product. To remove, press the clip and pull the filter cover away from the product J. Remove the filter. The exhaust filter is non-washable. Clean by shaking over a dustbin. To remove fine dust use the crevice tool brush to gently clean between the pleats. It is recommended that the exhaust filter is replaced every 6 months or sooner if it becomes damaged. IMPORTANT: • All filters should be checked regularly for signs of damage, preferably after each cleaning task. The filters must be replaced immediately if they become damaged. • Always disconnect the cleaner from the mains when checking filters. • Always make sure all filters are fitted before use. Failure to do so may result in damage to your product. Storage position When finished, you can store the tubes and accessories by locating the tube storage clip into the slot on the bottom of the cleaner as shown K. I J K 73174 rev4:73174 rev4 16/02/2009 15:53 Page 6

withstand normal day-to-day use, but an occasional wipe over with a damp cloth will help maintain its good looks. Abrasive cleaners should not be used. Purchasing filters Use original Morphy Richards spares & consumables. These can be purchased by telephoning the Morphy Richards replacement parts line. Safety cut-out If the cleaner overheats, a motor protection device will automatically switch the motor off. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for 60 minutes. Check the airways for blockages, empty the dust container, clean the dust container filter and replace the exhaust filter if necessary before restarting the cleaner. HELPLINE If you have any difficulty with your appliance, do not hesitate to call. We are more likely to be able to help than the store from where you bought it. Please have the following information ready to enable our staff to deal with your enquiry quickly: • Name of the product. • Model number as shown on the underside of the appliance. • Serial number as shown on underside of the appliance. UK Helpline 0844 871 0949 Replacement Parts 0844 873 0715 Ireland Helpline 1800 409 119 Website You may also contact us through our website, or visit the site to browse and purchase appliances, spare parts and accessories from the extensive Morphy Richards range. For details of other Morphy Richards products, please visit our website: 73174 rev4:73174 rev4 16/02/2009 15:53 Page 7

GUARANTEE It is important to retain the retailer’s receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. Model no. Serial no. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase, it should be returned to the place of purchase for it to be replaced. If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You may be asked to return a copy of proof of purchase. Subject to the exclusions set out below (see Exclusions), the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt. • Check the filters for blockages. • Check the tools / tubes for blockages. • Check the plug is firmly in the socket. • Check the socket is working by trying another appliance. • Check the fuse in the plug. If, for any reason, this item is replaced during the 2 year guarantee period, the guarantee on the new item will be calculated from original purchase date. Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase. To qualify for the 2 year guarantee, the appliance must have been used according to the instructions supplied. EXCLUSIONS Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where: 1 The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturer’s recommendations or where the fault has been caused by power surges or damage caused in transit. 2 The appliance has been used on a voltage supply other than that stamped on the products. 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). 4 The appliance has been used for hire purposes or non domestic use. 5 The appliance is second hand. 6 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 7 The guarantee excludes consumables such as bags and filters. • This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an additional benefit and does not affect your statutory rights as a consumer. • This guarantee is valid in the UK and Ireland only. Morphy Richards products are intended for household use only. Morphy Richards has a policy of continuous improvement in product quality and design. The company, therefore reserves the right to change the specification of it’s models at any time. The After Sales Division Morphy Richards Ltd Mexborough, South Yorkshire, England, S64 8AJ Helplines (office hours) UK 0844 871 0949 Spare Parts 0844 873 0715 Republic of Ireland 1800 409 119 VC73174 MUK Rev4 12/08 For electrical products sold within the European Community. At the end of the electrical products useful life, it should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice in your country. 73174 rev4:73174 rev4 16/02/2009 15:53 Page 8