Mojotone NC-1 Quick Installation

Text of Mojotone NC-1 Quick Installation

Using a Phillips head screwdriver,

loosen the cork padded mounting clamps on each side until the clamps are fully open. Insert the pickup into the soundhole from the treble side and grab the pickup with your other hand on the bass side to position the pickup into place. You want the pickup to be as close to the neck as possible. Center the logo under the strings. Tighten the clamps gently until the pickup is secure while leaving the cab

Mojotone NC-1 Remove the strings from the guitar.

Drill a ½’’ hole through the tailblock or use a tapered reamer to enlarge the existing hole. CAUTION: This step should only be performed by an experienced professional! Remove the strap button, small hex nut, and small dress washer from the smaller threaded portion of the endpin jack to allow the larger threaded barrel portion to pass through the hole from the inside of the guitar. Adjust the

While holding the endpin jack from the

inside of the guitar, install the smaller dress washer followed by the smaller hex nut on the outside where the jack is protruding from the guitar. Using a small screwdriver or hex wrench through the hole of the endpin jack, hold the jack in place while tightening the hex nut with an open end ½’’ wrench or adjustable pliers. Install the strap button and tighten with pliers using rubber or leather to protect the s

Install the 2 self-adhesive wire clips to

the inside of the guitar and hook the pickup lead wire into the bendable tabs securely out of the way. Preferably on the inside waist of the guitar. Using a Phillips head screwdriver, loosen the cork padded mounting clamps on each side until the clamps are fully open and insert the pickup into the soundhole. You want the pickup to be as close to the neck as possible. Tighten the clamps gently until the pickup is se

Mojotone Accessories For Music Instruments Owners Instructions: