HUTTON Security Shed Assembly Instructions
Text of HUTTON Security Shed Assembly Instructions
8' x 6' – Security Shed
1. Place the floor section on the base you have prepared
and fix the back panel to one side panel screwing through
the vertical battens of the back panel into the battens on
the side panel using 3x 70mm green screws. Repeat when
fitting the other side panel.
2. Fix the front panel (with door) to the two side panels as
in part 1 using 70mm screws provided. After all the panels
are fitt
5. Fix on the four corner strips with 3x 40mm nails in each.
6. Measure the length of the roof panel and add an extra
100mm for cutting the lengths of felt. (Three lengths will
be needed). Once the felt is cut lay the pieces to overhang
the side of the roof by at least 60mm. Lay the third piece
of felt along the centre of the roof to overhang the other
two pieces.
7. Nail the felt around the outside of the roof every
100mm.
8. Fit fascia pieces into place