Metrohm 802 Stirrer Manual 

Text of Metrohm 802 Stirrer Manual 

Phone +41 71 353 85 85
Fax +41 71 353 89 01 [email protected] www.metrohm.com 802 Stirrer Manual 8.802.8001EN / 2020-03-30
This documentation is protected by copyright. All rights reserved.
This documentation has been prepared with great care. However, errors can never be entirely ruled out. Please send comments regarding possible errors to the address above.
Table of contents
■■■■■■■■III Table of contents 1 Introduction 1 1.1 Instrument description ......................................................... 1 1.2 About the documentation ................................................... 1 1.2.1 Symbols and conventions ...........
Table of figures
■■■■■■■■■■■■■■■■■■■■■■ IV ■■■■■■■■ Table of figures Figure 1 802 Stirrer ......................................................................................... 5 Figure 2 802 Stirrer with its own control ......................................................... 6
The propeller rod stirrer 802 Stirrer is controlled by a Touch Control or a
computer software. It however has its own control. The stirring rate is set by a controller. The 802 Stirrer can be connected to a tit
1.3 Safety instructions
■■■■■■■■■■■■■■■■■■■■■■ 2 ■■■■■■■■ Warning This symbol draws attention to a possible biological hazard. Caution This symbol draws attention to a possible damage of instruments or instrument parts. Note This symbol marks additional information and tips. 1.3 Safety instructions
An incorrect supply voltage can damage the instrument.
Only operate this instrument with a supply voltage specified for it (see rear panel of the instrument). Protection against electrostatic charges WARNING Electronic components
1.3 Safety instructions
■■■■■■■■■■■■■■■■■■■■■■ 4 ■■■■■■■■ 1.3.5 Recycling and disposal This product is covered by European Directive 2012/19/EU, WEEE – Waste Electrical and Electronic Equipment. The correct disposal of your old instrument will help to prevent negative effects on the environment an

Metrohm Laboratory Equipment Owners Instructions: