Next LEAMINGTON DOUBLE BED Assembly Instruction

Text of Next LEAMINGTON DOUBLE BED Assembly Instruction

If you have any problems with this product or

require any replacement fittings please contact Customer Services Tel: 0844 844 8999 • For general cleaning, periodically dust with a soft cloth. • Do not put hot dishes directly on the surfaces of the item. • Never drag pieces of furniture across the floor as this will cause damage to the joints. • All assembly fixings should always be tightened properly and periodically check al

A.Bolts x 12

M6X20mm H.Spanner x 1 C.Bolts x 4 M6X55mm E.Plastic Washer x 8 D.Nut x 2 M6 G.Allen key x 1 F.Metal Washer x (1)Headboard x 1 (2)Footboard x 1 (3)Side Rail x 2 (5)Center Rail x 1 (4)Cross Bar x 2 (6)Sprung Slats x 30 (7)Plastic cap (one end open) x (11)Finials x (10)Fabric x 2 (13)Supporting x 2 (8)Plastic cap B.Bolts x 4 M6X40mm (12)Foam Pads x 4 (9) Foot Slider x 4 Page 2 of 5

1. Attach side rails 3 (x2) to headboard 1 and

footboard 2 using 8 x bolts (A), 8 x plastic washers (E) and 8 x metal washers (F). Tighten using Allen key (G) NOTE: Ensure the threaded insert holes in cross bars 4 (x2) are facing downwards STEP TWO STEP ONE 1.Attach Foot Slider (9) to Headboard 1 and Footboard 2 by using Bolts (B), Metal Washer (F)and tightening with Allen key (G).Peel the rear tape from the Foam Pads (12) and stick them to the base of

1. Attach centre rail 5 between the brackets on cross

bars 4 (x2) using 2 x bolts (C), 4 x metal washers (F) and 2 x nuts (D). Tighten with Allen key (G) and NOTE: Please ensure that the slat cap holes on the centre rail 5 face upwards. 1. Attach 2x support leg 13 to centre rail 5 using 2 x bolt (C), 2x metal washer (F) and tighten with Allen key (G). IMPORTANT Once the feet have been assembled and attached, they should be adjusted to ensure they do not t

1. Insert a sprung wooden slat 6 through the first

hole in strap 10. Repeat using another sprung wooden slat 6 and the other strap 10. 2. Attach single sided slat cap 7 onto one end of the sprung wooden slat 6. Attach another single sided slat cap 7 onto the other end of the second sprung wooden slat 6. 3. Attach both sprung wooden slats to the assembled bed base by inserting each single sided slat cap 7 into side rails 3 (x2) and using double sided slat c

Next Indoor Furnishing Owners Instructions: