Next 893141 Assembly Instructions Manual
Text of Next 893141 Assembly Instructions Manual
If you have any problems with this product or require any
replacement fittings please contact Customer Services Tel:
0844 844 8999
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found to be
faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• Carefully check that you have all parts before
1. Insert 6 x cambolts (A) into panels 1 & 2 and tighten with
a screwdriver.
STEP ONE
FITTINGS
Please note:Remove the protective film after assembly of this product, this will
prevent accidental scratches during assembly.
PARTS
1Χ1
2Χ1
3Χ1
7Χ2
4Χ2
5Χ2
6Χ1
AΧ6
BΧ6
CΧ12
7.5*35m/m
15*10m/m
6*30m/m
DΧ1
5g
EΧ6
25mm
FΧ8
5*16m/m
H35A+H=0
GΧ2
4*14m/m
HΧ12
IΧ8
Template
JΧ1
Page 2 of 6
1. Glue(D) and insert 6 x wooden dowels (C) into panel 1
and attach panels 5(x2) & 6 to panel 1.
2. Insert 3 x camlocks (B) into panels 6 & 5(x2) and tighten
with a screwdriver.
Ensure the arrow indicator is pointing towards the panel
edge and ensure the assembly bolt locates properly into
the camlock before turning
1. Slide panels 4(x2) into the assembled unit as shown in
diagram.
1. Glue(D) and insert 6 x wooden dowels (C) into panels
5(x2) & 6 and at
1. Attach 2 x hinges (G) to panel 3 with 4 x screws (H) using
a screwdriver clockwise until tight.
NB: Put the styrofoam under panel 3 to protect the mirror
1. Attach panel 3 to panel 1 with 4 x screws (H) through
hinges (G ) to fit the adjustable holes first and using a
screwdriver to tighten.
NB: Put the styrofoam under panel 3 to protect the mirror
To align doors use the adjustment diagram
below.
LATERAL
VERTICAL
FRONT- TO-BACK
3. once doors are co
1. Use the template (A) provided to mark on the
wall the position of the fixings.
NB: Place the template over the back of the
cabinet to ensure that the holes match the
position of the hooks before drilling into your
wall
2. Use a spirit level to check that the fixings are level.
3. Drill four holes and insert an appropriate wall plug into
each. Insert the screws/washers and tighten . leaving the
screw head exposed by about 1/4 inch(6mm).
Warning:
Always
1. Insert 8 x fittings (F) into the required position .
3. Insert panels 7(x2) onto the fittings (F) .
Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
STEP TEN
Style 1
Style 2
Page 6 of 6