Makita XPK01 Instruction Manual

IMPORTANT: Read Before Using. IMPORTANT: Lire avant usage. IMPORTANTE: Leer antes de usar. Cordless Planer Rabot sans Fil Cepillo Inalámbrico XPK01 011751 ...

SPECIFICATIONS Model XPK01 Planing width 82 mm (3-1/4") Planing depth 2 mm (5/64") Shiplapping depth 9 mm (11/32") No load speed (RPM) 15,000 /min Overall length 333 mm (13-1/8") Net weight 3.1 kg (6.8 lbs) 3.4 kg (7.4 lbs) Rated voltage D.C. 18 V Standard battery cartridges BL1815N / BL1820 BL1830 / BL1840 / BL1850 • Due ...

balance at all times. This enables better control of the power tool in unexpected situations. 15. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. 16. If devices are provided ...

only when hand-held. 15. Always change both blades or covers on the drum, otherwise the resulting imbalance will cause vibration and shorten tool life. 16. Use only Makita blades specified in this manual. 17. Always use the correct dust mask/respirator for the material and application you are working with ...

battery cartridge is removed before adjusting or checking function on the tool. Installing or removing battery cartridge 1 2 3 011755 CAUTION: • Always switch off the tool before installing or removing of the battery cartridge. • Hold the tool and the battery cartr ...

pulled, a lock-off lever is provided. To start the tool, slide the lock-off lever and pull the switch trigger. Release the switch trigger to stop. WARNING: • For your safety, this tool is equipped with lock-off lever which prevents the tool from unintended starting. NEVER use the tool if it runs when ...

plate and screw in the three hex flange head bolts so that a gap exists between the drum and the set plate to slide the mini planer blade into position. The blade will be positioned by the planer blade locating lugs on the set plate. 7. The blade's lengthwise adjustment will need to be ...

Your planing surface will end up rough and uneven, unless the blade is set properly and securely. The blade must be mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base. Below are some examples of proper and improper settings. (A) (B) (B) (A) (B) (A) (A) Front base (Mov ...

011757 For tool without nozzle When you wish to perform clean planing operation, connect a Makita vacuum cleaner to your tool. Before connecting the vacuum cleaner, remove the chip cover from the tool. Then connect a hose of the vacuum cleaner to the nozzle (optional accessory) as shown in the figures. For tool with nozzle When ...

fence into the hole in the front of the tool. Align the blade edge with the cutting line. 1 2 011760 Adjust the edge fence until it comes in contact with the side of the workpiece, then secure it by tightening the screw. 011761 When planing, move the tool with the edge fence flush with the side of the ...