LauraStar SMART Instruction Manual

27 LAURASTAR LAURASTAR LAURASTAR  1 1  2 2  3 3  3  3a  4 4  5 5  6 6  6  6a  7 7  8 8  9  10  13  14  15  17 16  20  22  23  24  25  18  19  21  26  26  12  11  11  28 Opt. 3 Opt. 2 - 2 - ...

instruction manual and the safety instructions may result in serious injury or damage to property. The manufac- turer accepts no responsibility for such injury or damage in the event that these safety instructions are not followed. Keep this instruction manual for refer- ence by any and all persons who may use the appliance. WARNING: Your LaurastarTM product generates heat and steam. Various parts of the appliance may become very hot during operation and can cause burns. NOTE : This appliance generates heat and can cause burns. Those parts which get very hot are marked with this symbol. Table of conte ...

2. To avoid the risk of electric shock, do not immerse the iron in water or other liquids. 3. Always turn the iron OFF before plugging or unplugging the iron from the electrical outlet. Never pull on the cord to disconnect the iron from the electrical outlet; instead, grasp the plug and pull on the plug to disconnect the iron. 4. Do not let the cord touch hot surfaces. Let the iron cool completely before putting the iron away. Coil the cord loosely around the iron when storing. 5. Always disconnect the iron from the electrical outlet before filling the iron with water, emptying the water from the iron ...

on the heat-resistant iron rest. • Cleaning, repairs, and maintenance on the appliance should ONLY be performed when the iron is switched off, cold and allowed to cool down for at least 2 hours. Unscrew the caps with care: any pressurized steam present will begin to escape after a few turns, posing a risk of burns. • Allow the iron to cool down completely before storing. • DO NOT operate the appliance without water. • Clean the exterior of the appliance with a soft, damp cloth. DO NOT use solvents, oil or petrol. • DO NOT attempt to insert objects into the openings of the appli ...

Installing your ironing system • Remove the appliance from the box and position it vertically on the ground in a closed position. • Hold the table with one hand on the iron rest side (6). Hold the middle of the table (1) with the other hand and pivot it to a horizontal position (maximum height). A B • Unfold the iron-rest to the open position. • Fit the ironing board cover (4), securing it from the side of the iron rest to the tip of the ironing board, then adjust. The cover supplied with this product is specially designed to ensure uniform distribution of air over the whole board in vacuum or blower mode. U ...

Your Laurastar has been designed for use with tap water. It is still absolutely necessary to use the supplied anti-scale filter (13) in order to benefit fully and longer from your Laurastar. NOTICE: Never use additives (e.g. per- fumed water), water containing chemical products or water from tumble dryers as these products will have a detrimental effect on the function of your Laurastar. Storing your system • To turn your appliance off, press the main ON/OFF button (16). • Remove the power plug (23) and roll the electric cable around the feet of the table. If your model has the automatic rewind, pull on the cab ...

LauraStar Auto Picto 01/09/16 Start up CAUTION: ALWAYS fill the water reservoir (11) completely be- fore turning on your Laurastar. Operating the appliance with- out water could damage the appliance. PLEASE NOTE: Operating the appliance without water will void any limited warranties provided with your appliance. Installation of the anti-scale cartridge and filling • Check that the power plug is disconnected from the mains socket. • Set the ironing board to its highest position. • Take the water reservoir (11) out. Ta ...

iron’s steam button (9) 2 or 3 times, while pointing it away from the clothes. This will release any condensation from the iron and prevent water marks on the clothes. CAUTION: Do not point the iron at people or pets while using vertical steam. Ironing Two ironing modes For the best possible steam ironing result, we offer two modes of ironing : • Blower mode: Pressing the vacuum/blower button (10) on the iron activates the fan (24) in blower mode. this blows air into the fabric from below, helping to reduce unwanted creases. • Vacuum mode: Pressing the vacuum/bl ...

become shiny, for delicate fabric like silk and synthetic fabrics which have a tendency to stick to the iron. Using the protective soleplate (27): • First place the tip of the iron (2) at the front of the protective soleplate (27) and lower the iron to fix it in place in the soleplate. • Wait approximately 2 minutes for the soleplate to reach the correct temperature. • To remove the protective soleplate, pull on the tab and remove the iron while it is still hot. WARNING: The protective soleplate is hot! Use caution when you remove ...

A warning tone sounds and the empty water indicator light (20) flashes to signal that there is no water left in the steam generator’s reservoir. As soon as the warning tone sounds, the steam stops and you must refill the water reservoir (11). How to fill the water reservoir (11) • Remove the water reservoir (11) from its place. Take off the reservoir lids. • Fill the reservoir with tap water. The filtered water must reach the MAX level. • Close the lids and put the reservoir back in its place on top of the steam generator (15). EN LAURASTAR LAURASTAR bip MAX  A  B B A ...

the steam generator and clean your iron every month or after every 10 hours of ironing. WARNING: the appliance should be UNPLUGGED, OFF and COLD before cleaning. Switch off and unplug the appliance. Allow your appliance to cool down for at least 2 hours. Always make sure your appliance is cold before cleaning ! NOTICE! Only rinse the appliance with water. NEVER use descaling products or other chemical products. Cleaning the iron (2) If the iron’s soleplate is dirty, use the cleaning mat in accordance with the instructions. This can be obtained at www.laurasta ...

In order to prolong the effectiveness of your appliance and avoid any traces of limescale, you must rinse the steam generator (15) on a regular basis. WARNING: Only rinse with water. NEVER use descaling products or other chemical products. Rinse the steam generator in accordance with the following instructions : • Check that the power plug (23) is disconnected from the mains socket. • Set the ironing board (1) to its highest position, then remove the wa- ter reservoir (11). Place the drain tray (14) beneath the drain cap  (22). • First unscrew the steam generatorc ...

Before calling the Laurastar Customer Service department, please check the following points: Symptom Likely cause Remedy GENERATOR Makes a buzzing noise when steam is emitted from the iron. Vibration from the appliance. This noise is normal for a new appliance, it will disappear in the course of use. Makes a crackling noise when the appliance is switched on. The appliance has been set to heat up but has not been filled with water. Fill the water reservoir (11) The iron no longer emits steam. The pressure has fallen. • The steam generator is empty. • The appliance is switched off. • The plug (23) is disconnected f ...

1,1 l 37,2 oz. Electricity supply 220-240 VAC / 50-60 Hz 120 VAC / 60 Hz Weight of iron 1,1 kg 2,4 lb Total weight 23,1 kg 51 lb Board height 82-102 cm 32.3-40.2 in Dimensions when folded (H x W x D) 132 x 42 x 22 cm 52 x 16.6 x 8.7 in Designation: Pressure steam ironing system ...

The present guarantee does not, in any way, affect the sta- tutory rights of the user pursuant to the national legislation in force governing the sale of consumer goods, including the rights set out by Directive 2011/83/EU of the European Parliament and of the Council of 25 October 2011 on certain aspects of sales and guarantees for consumer goods, or the rights held by the user, by virtue of the sales contract, with regard to the respective vendor. In the event that an appliance sold by Laurastar contains manufacturing defects, Laurastar shall be liable for the complete elimination of these defects within t ...

from the present declaration In order to assert the entitlements resulting from this guarantee, the user must contact the Laurastar Customer Service department, either : • by telephone • by e-mail • by fax. He / she must follow the instructions from the Customer Service department and send, at his / her own risk: • the appliance with the defect(s) • a copy of the purchase contract, of the invoice, of the till receipt or any other suitable document as evidence of the date or place of purchase. The Customer Service department is available to provide any additional inform ...

27 LAURASTAR LAURASTAR LAURASTAR  1 1  2 2  3 3  3  3a  4 4  5 5  6 6  6  6a  7 7  8 8  9  10  13  14  15  17 16  20  22  23  24  25  18  19  21  26  26  12  11  11  28 Opt. 3 Opt. 2 - 18 - ...

av bruksanvisningen og sikker- hetsinstruksjonene kan lede til alvorlige helseskader eller skade på eiendom. Produsenten påtar seg intet ansvar for slik skade dersom disse sikker- instruksjonene er ikke fulgt. Be- hold denne bruksanvisningen som referanse for alle personer som kan komme til å bruke apparatet. ADVARSEL: Ditt produkt fra LaurastarTM genererer varme og damp. Forskjellige deler i apparatet kan bli veldig varme under bruk og kan forårsake brannskader. MERK: Dette apparatet genererer varme og kan forårsake brannskader. Innholdsfortegnelse Sikkerhetsinstruksjoner 20 Laurastar Smart App 22 In ...

2. For å unngå fare for elektrisk støt, ikke senk strykejernet i vann eller andre væsker. 3. Skru alltid AV strykejernet før du setter inn eller tar ut stikkontakten fra støpselet. Dra aldri i ledningen for å koble strykejernet av strømforsyningen, ta i stedet tak i kontakten og dra i den for å koble av strykejernet. 4. Ikke la ledningen være nær varme overflater. La strykejernet kjøles helt ned før du rydder det bort. Rull ledningen forsiktig rundt strykejernet når du rydder det bort. 5. Koble alltid av strykejernet fra strømforsyningen før du fyller strykejernet m ...