Dell 1907FPc Service Manual
Text of the manual
19” LCD MONITOR
DELL 1907FPc
THESE DOCUMENTS ARE FOR REPAIR SERVICE INFORMATION ONLY.EVERY REASONABLE EFFORT
HAS BEEN MADE TO ENSURE THE ACCURACY OF THIS MANUAL; WE CANNOT GUARANTEE THE
ACCURACY OFTHIS INFORMATION AFTER THE DATE OF PUBLICATION AND DISCLAIMS RELIABILITY FOR
CHANGES, ERRORS OR OMISSIONS.
Service Manual
Table of contents
Table of contents------------------------------------------------------------------------------------------------------------------------- 02
Revision List -------------------------------------------------------------------------------------------------------------------------------03
Important Safety Notice ----------------
Revision Release Date
Revise history
TPV model
Remark
T980KSCDKRDFUP
T980KSCDKRDMUP
T980KGCHKRDGUP
A00
Nov.-28-2005
Initial Release
T980KGCHKRDEUP
A01
Dec.22-2005
Sold area in EU and attach the
corresponding BOM
T980KSCHBRDGQP
A02
Mar.-28-2006 Add “Definition Of Pixel Defects”
A03
April-25-
Important Safety Notice
ANY PERSON ATTEMPTING TO SERVICE THIS CHASSIS MUST FAMILIARIZE HIMSELF WITH THE CHASSIS
AND BE AWARE OF THE NECESSARY SAFETY PRECAUTIONS TO BE USED WHEN SERVICING
ELECTRONIC EQUIPMENT CONTAINING HIGH VOLTAGES.
CAUTION: USE A SEPARATE ISOLATION TRANSFORMER FOR THIS UNIT WHEN SERVICING
REFER TO BACK COVER FOR IMPORTANT S
1. Monitor Specifications
Screen type
Active matrix - TFT LCD
LTM190EX-L01 (LPL)
Panel Type
LM190E03-TLB4 (SEC)
Size
480mm(19.0")
Display Area
376.32(H) x 301.056(V)
Pixel pitch
0.294mm(H) x 0.294mm(V)
150(H) / 135(V) (type) (For LTM190EX-L01 panel)
Viewable angle (CR>=10)
140(H) / 140(V) (type) (For LM190E03-TLB4 panel)
LCD Panel
Response
2. LCD Monitor Description
The LCD monitor will contain a main board, Power board, key board, and USB board which house the flat panel
control logic, brightness control logic and DDC.
The power board will provide AC to DC Inverter voltage to drive the backlight of panel and the main board chips
each voltage.
Monitor Block Diagram
Video signal
3. Operation instructions
3.1 General Instructions
Press the power button to turn the monitor on or off. The other control buttons are located at front panel
of the monitor. By changing these settings, the picture can be adjusted to your personal preferences.
- The power cord should be connected.
- Connect the video cable from the monitor to t
Use the Input Select button to select between two different video signals that may be
connected to your monitor.
NOTE: The floating 'Dell Self-test Feature Check' dialog appears on a black
background If the monitor cannot sense a video signal. Depending upon the
selected input, one of the dialogs shown below will scroll continual