Ground Zero TITANIUM Series Owner's Manual

• Linkable 2 Ohm • Mosfet power supply • Power and protection indicator • Variable 12dB Bass boost (45Hz) • Phaseshift 0 / 180° (Switch) • Variable Subsonic • Variable Lowpass • Adjustable input sensitivity • Soft delayed remote turn on � ...

• Screwdriver • Electric drill, 3 mm / 0.12” carbide drill bit • Mounting screws • Power wire min. 25 mm² / 4AWG • Ground wire min. 25 mm² / 4AWG • Speaker wire min. 2 x 2,5 mm² / 13AWG Please note • As a precaution it is advisable to disconnect the vehicle’s battery before making connection to the +12 Vol ...

DC electrical connections must be fused on the battery side. Make sure your radio and all other devices will be turned off while connection your system. If you need to replace the power fuse, replace it only with a f ...

1 Speaker terminals For connection of the subwoofer 2 Power terminals GND -> Ground connection REM -> Remote antenna terminal BATT -> +12 Volt 3 Satus indication GREEN – OK RED – Error 4 Cinch inputs Terminal for connection of the RCA wires. To avoid failure, please use high quality RCA wires. 5 Input level controller With this c ...