Jensen LXA600 How To Install And Operate

the LXA600 Amplifier ® Contents Technical Assistance For technical assistance with the operation or installation of the LXA600, call 1-800-323-0221. Welcome! What you're holding in your hands is no ordinary owner's manual. We've tried to make the instructions in this book clear and easy to follow. For your Jensen amplifier to wor ...

greater flexibility in mounting. It can be mounted under a seat or in the trunk. When selecting a location, remember that amplifiers generate heat. Select a location where air can circulate around the amplifier. Do not cover the LXA600 with carpets or enclose it behind interior tri ...

Supplies: • Speaker wire (12 gauge for subwoofers, 16-18 gauge for other speakers) • Sheet metal type screws for mounting amplifier • Electrical tape • Solderless crimp connectors • 1/2" thick plywood or particle board to mount amplifier on Tools: • Flat and Phillips screwdrivers • Wire cutters • Wire str ...

Remote Terminal (RMT +12V) Power Terminal (BATT +12V) Connect directly to the vehicle battery+ terminal with 8 gauge wire (minimum). Ground Terminal (GND) Connect to a good chassis ground. The ground connection should be to clean, unpainted metal to provide a good electrical connection. Connect the radio power antenna le ...

Input Wiring Low Level Input Use a pair of shielded stereo audio cables with RCA type jacks. Most trunk-mount amplifier installations require 20-foot RCA cables. Most under-seat and pickup truck installations use 12-foot cables. Connect RCA cables from your receiver to the RCA input jacks on the amplifier. High Level Input Con ...

chosen installation method. Use LPF and HPF to adjust from 40 to 240Hz. When using your Jensen amplifier to run a subwoofer and two full- range speakers (known as Tri-mode or three channel operation) you will need to purchase separate high and low pass crossovers from your local retailer. A pair of high pa ...

4 CH MODE, the amplifier will operate as a standard 4 channel amp with all RCA inputs con- nected. 4 Channel Mode 4CH 3CH 2CH MODE RCA Inputs When the input selector is in the 3 CH MODE, the amplifier is configured for stereo/mono opera- tion. The front channels of the amplifier (A and B) operate in stereo mode. ...

2 Subwoofers/Bridged Mono 4 Speakers A-CH B-CH C-CH D-CH + – – + + – – + RCA Cables 2/4Ω 2/4Ω 2/4Ω 2/4Ω OFF ON LPF FULL HPF BASS-BOOST OFF ON BASS-BOOST X-OVER LPF FULL HPF X-OVER CH A/B CH C/D A-CH B-CH C-CH D-CH + – – + + – – + RC ...

2 Speakers + Bridged Subwoofer Important When running a subwoofer and two full-range speakers together (Tri-mode operation), high and low pass filters must be used. Failure to install these filters will damage your amp and/ or speakers. A-CH B-CH C-CH D-CH + – – + + – – + RCA Cables 4Ω 4Ω 4Ω 4Ω min ...

1. Turn on the receiver but do not turn up the volume. The amplifier power light should come on. If not, check the RMT and +12V wires. 2. Turn up the receiver volume slightly. All speakers should operate. If not, check wiring connections at amplifier and speakers.  Testing Test Speaker Connections These tests make sure the spe ...