Jamara Fokker DVII Instruction

is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. ...

when drop instant glue to secure the dowel on the W5. Try to fit the W3 on the main wing as the middle edge. TOP MAIN WING ASSEMBLY When satisfy the location; place some heavy thing (1 KG) on the middle edge. Place a long straight ruler on the leading edge. Make sure the angle between the ri ...

BOTTOM MAIN WING ASSEMBLY Try to fit the W22 on the main wing as servo tray. Press the W22 into the slots and drop some instant glue to secure it in place. Try to place the 3mm wide of MW3 on the bottom of the MW2 (the side without any gaps). Use triangle rulerwhen apply instant glue. Place W23, W24, W25, W26, W27 as the picture indi ...

picture shown. Left MW9 combination must be on the left side. Don‘t use any glue. Top view of the left and right MW11 combinations. Make sure the alignment of every rib and place some heavy thing (1 KG) on themiddle edge. Place a long straight ruler on the lea- ding edge. Make sure the angle b ...

its relative slots on the MW5. Drop instant glue to secure them in place. Please check if there is any joint places need to be secured by instant glue. Apply some UHU glue on the joint places of leading edge (dowel) and ribs. Wipe off the excess glue. Use sanding paper to trim the uneven surfac ...

Try to fit DW4 to the bottom of the sub wing as the rear edge. Drop some instant glue to secure it in place. Completion of the sub wing and wit for apply films. Close view of the round edges. It makes the horizontal looking better and avoiding disturbed flow. Place DW1 on the working table. Pl ...

(angle is around 30 degree on one side). Use sandingpaper to trim the surface. Don‘t trim too much. Try to fit the hinges into the holes. Close view of the V shape on the tip. It is also workable to use sanding paper to trim the tips into V shape; but be careful, don‘t trim too much. Use sand ...

elevator. Try to fit V4 into V2; fit H5 and V5 into V3. Use instant glue to secure V4, H5 and V5 in place. RUDDER ASSEMBLY Use sanding paper to trim the top edge into round edge. Close view of the round edge. Use wooden planning tool to trim the leading edge of the V3 into V shape (30 degree). Us ...

on V1. Use hobby knife to cut the hinge hole on V1. Wait for applying film. Place F6 and F7 on the working table. Use glue to secure the F6 and F7 together. Please note the small recess on the top of the left sides and the alignment of every side. Wipe off the excess glue. Pla ...

Use glue to secure the F1R on the F2R and secure F1L on the F2L. Place some heavy thing on the F1R and use instant glue to se- cure the F1R on the F16 combination. Place the F10, F11, F12, F13, F14, F19 and F28 on the working table as the picture shown. Try to fit the F5 on the F16, before the F6. ...